20 Most Recent
1992 Dodge Caravan - Page 8 Questions & Answers
Driver side brake caliber is locking after the
sounds like the slide pins need to be looked at for ware, marks, scoreing.If there is no marks then just regrease and put back in ,but make sure you use grease that is recomended for break calipers.if cost is a factor for the grease then you can use high temp bareing grease.they also have replacements at most autoparts stores if 1 should break.if this doesnt fix it then start looking at the rubber break line as these can swell inside over time and particles can collect in side it and mess with the fluid flow,those are the cheepest to replace.after those then comes checking the proportioning valve and or master cylinder.and maybe replaceing the caliper its self.
Engine rotates but won't start
Here are a few things you can try to debug the no spark issue. I hope these help you out.
1. Remove the distributor cap and crank the car. If the rotor turns you're ok. If it doesn't turn then that's you're problem and you will probably need to change a timing belt/chain.
2. Check the spark from the ignition coil by pulling the coil wire from the center of the distributor. Use an alligator clip to attach a short wire to the coil wire contact. Bare the other end of this short wire and set it up so it's sitting very close to the engine block. Turn off the lights and try to start the car. You should see a spark jump from this wire to the block. If you don't see a spark it's likely your ignition module or ignition coil is bad.
3. If you have a spark maybe it's not getting to the plugs. You may need to replace the distributor cap and rotor. You can test if the plugs are sparking by pulling one, re-attaching the spark plug wire and seeing if you get a spark when you try to start the engine in the dark. Please note, the metal threads of the spark plug need to be shorted to the engine block to complete the circuit during this test.
Driver side wiper dont work
vehicle may have a stripped wiper arm.( remove wiper arm,turn on wipers & see if splined knob is moving ),if so turn off wipers & replace wiper arm.or if knob does not move then have to remove cowel & check linkage to wiper transmission!
No oil to back of motor 1992 dodge caravan
You either have a blocked oil line or a blown head gasket blocking the oil line. Check the oil for any signs of white residue. This is a sign of a headgasket leak or break up. Good luck!
Dashboard gauges dont work, 1998 dodge caravan
These vehicles seem to have a problematic short, my grandfather has the same vehicle with the same problem, i found the short under the carpet on the driver side of the vehicle, under the gas pedal, sometimes wires can crack and break.
MIKE
The radiator fan does
Hi!!
Apply 12v current straight to fan from battery to test fan motor, if it starts, then check the coolant temp. sensor, usually on or near thermostat housing. Also check for broken wires and loose connections.
Good Luck!! Don't forget to change this post!!
When driving the speedometer needle jumps all over
replace the speed sensor on the passenger axle next to the transmission. It is held in place with a ten millimeter bolt.re-installed it and works perfect again. This very same thing was happening to my 92 dodge caravan two days ago.went down bought a new sensor, took the gear off the old one and popped it on the new sensor, re-installed it, works perfect again. Let me know if this does the trick. Good Luck. Ps make sure to get the same two or three prong sensor. Was about a $27 fix.
Inner spline will not disengage from the diff on
Hi, its a tough one, but it will come out. try to use a pry bar with a slightly bent tip, you miHT have to turn axle till one of the "bells"is in a reachable place to put the tip between the axle and the trans case. prybar should have its length towards rear of car, maybe add a 3 to four foot pipe over it to add leverage. if that fails, then you have to remove the passenger axle, using a railroad spike or old 1/2 drive extension, you can drive out the driver side axle from the passenger side axle housing.
Transmission wont drive except for
check your transmition flewed level if its too low your van will only g in reverse put some in if your tranny is leaking replace it if its the tranny casing its self if its around the pan replace the pan gasket also check the hoses going from the tranny to the radiater
i hope this helps
I connected the wrong battery cables in my car
Hi!!
Check the Alt. Fuse in the engine compartment fuse box, if Ok, take vehicle to an AutoZone or Checkers store and have them check your charging system,
I think the battery is toasted and/or the alternator regulator is not working properly. If the alternator and battery test fine, then your problem could be a broken, burned out or loose wire.
Don't forget to rate this post!! Good Luck!!
How to replace ignition
There are a couple of different scenarios if I remember correctly. If you have a key that will turn the ignition cylinder then it will be easy. Follow these steps.
1. Disconnect Battery
2. Remove the plastic shroud around the steering column
3. Insert key and turn to the accessory position
4. Insert a small ice pick into the retainer hole( it is usually on either the top or bottom of cylinder ) and then pull on ignition at same time
If you do not have an existing key then you will need to drill the wafers out of the ignition in order to get it to turn to the accessory position. Just be careful not to drill too deep so as not to damage the ignition housing. If you need a replacement ignition for your caravan go
here, they provide free installation support via email and chat.
Need the wireing order for a 1992 dodge caravan in
For the 3.3L:
Firing Order:
1-2-3-4-5-6
Cylinders:
(back of vehicle)
1--------3--------5
2--------4--------6
(front of vehicle)
Ignition Coil:
(back)
6---3
4---1
2---5
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!
Not finding what you are looking for?