20 Most Recent 2002 Nissan Pathfinder Questions & Answers

no. the transmission has a fuse. why you ask?

all other electrics ok in car, and starts and drives the car? all exterior lamps work? brake,turns/stop ;heads? wrong lamp, not using correct lamp shown in the glove box guide. the lamp has 3 modes on most cars. off all the time (disabled by a switch) on all the time. or door open activated. or a fuse is blown, I check them all. all door locks work"?? car has smart entrance control module my guess is fuse to it blown. 1 of the 4 to it. F10, F11,F24 named fuses the dome does have manual on switch if it is dead then spot and vanity lamp are dead too, that means fuses blow.above;. discover the manual switch yet on lamp socket dome? but the 3 fuse must be good told above first

Your first problem is no power to the coil/s. This could be the ignition switch or wiring from there to the coils. With ignition on, you should have 12 volts to the coil/s. The ECM grounds it out with help from the crank sensor. If you turn the ignition switch on and have the dash gauges and hear relays kick in, then check for bad/broken wires. Several things come on while in the run position. Like radio, blower fan, lights/gauges in the dash. If they don't come on, first would be checking the switch, then wires. You need a volt ohm meter, electrical shcematics.

replace head unit in dash

https://shoptoolreviews.com/automotive/diagnostic-testing/parasitic-battery-drain/34587/

hi, this was difficult to locate, its at autozone.com under power supply there are more diagrams there. have to sign up, but its free
jm

Try this link. Yours seems to a common problem. https://www.fixdapp.com/blog/p0305

GET YOUR BATTERY LOAD TESTED ALONG WITH YOUR ALTERNATOR TESTED FOR OHMS VALUES AT THE REGULATOR. ALSO MEASURE THE VOLTAGE WITH ALL LIGHTS, AC, RADIO ON. SHOULD BE THE SAME AS BATTERY OUTPUT.

I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 yearsmust try this bitman and reliable-store. Both are good

I think you should go for manual first after that it will be easy for u to solve your problem. I had visited this site past 2 months before for my vehicle and find it quite helpful may be you will also get something useful here 2002 Nissan Pathfinder

The blend door actuator has likely failed. Unfortunately, it's a real pain to replace. There is a procedure at the link below. Repair Guides Blend Door Actuator Removal Installation AutoZone com

poo11 mean low oil poo21 dirty oil and po1456 evap canister leak

While you have the "BATTERY" (always the GROUND side first)... disconnected... Snap a picture of where & how the wires are routed to the starter solenoid... The fact that the STARTER is spinning.. is a SOLENOID issue... but your FAILURE TO INDICATE that was TURNING OVER THE ENGINE also indicates a FATAL issue with the starter As you can see from the AMAZON pictures these are gear-reduction COMBINED units... My best advise is to cross check your cost w/rock-auto... and get a decent rebuilt.. This time DON'T RECONNECT THOSE WIRES until you have a new/rebuilt starter there... Good luck. http://www.rockauto.com/en/catalog/nissan,2002,pathfinder,3.5l+v6,1431960,electrical,starter+motor,4152

left side intake rear

A set of new spark plugs and check the air filter.