20 Most Recent
1995 Dodge Ram - Page 7 Questions & Answers
I have a 1995 dodge ram 1500 5.9 automatice 2
code - 37 TCC brake switch circuit error. this is the torque converter clutch. Open or shorted condition detected in the torque converter part throttle unlock solenoid control circuit
- For turbocharged engines
, code 37 will be triggered when the baro-read solenoid circuit is open or shorted.
- For normally aspirated (non turbo) engines with automatic transmissions, code 37 will be triggered when the Part Throttle Unlock (PTU) solenoid circuit is open or shorted.
- For normally aspirated cars with manual transmissions, code 37 is sometimes set for no apparent reason.
This is detected when the ECU doesn’t sense near 0vdc or 12vdc at the relay when the solenoid is turned on or off. When code 37 is thrown the power limited light will not be lit and the system will not enter limp mode.
Missing engine
You have to check what cylinder is missing. Maybe plug is not good may be wire
Dodge Ram 1500 4x4 year 1995 5.9 liter
Most of the problems are caused by the converter. You must replace the converter when rebuilding or replaceiong the transmission. I knoe because I have several and that is the main problem, it goes out and damages the trans. I go with a heavey duty or bullit converter. I have several dodge rams with well over 300,000 miles anddo a lot of plowing and towing. I would order a heavy duty over the internet, not use the standard. Check with
www.transmissioncenter.net or
http://tpiconverters.com/
1995 dodge Ram odometer
Replaceing a sensor should not affect the spedo. It is ran directly from a switch on the side of the trans
1995 doddge ram 2500 v 10 cold starting problems.
until you have actually tested components like the crankshaft sensor and the ignition module and the actual fuel pressure it anyones guess. Recommening a part without any data or testing informaation can get more expensive than if you just let a shop fix it for you. Go to mitchell1diy online if you don't know what to do and you have the ability and tools to diagnose this otherwise your most likley going to end up in the shop.
My truck won't start i replaced ignition the
- This is the starter sequence on some dodge trucks
- turn the key to start
- start signal goes to computer
- computer closes a starter relay in the relay box ( underhood )
- starter relay in box triggers the starter soleniod on the starter.
- PS could there be an aftermarket alarm system on the truck?
- some alarms only interupt the starter signal
I have no brake lights or turn signal but i have
It sounds like your fuse is blown. Brake lights and turn signals have a different circuit than the headlights. Check the fuse first if that doesn't work look for shorts in the wiring. If you have a plug-in for a trailer hookup one of the wires may have come loose and grounded out.
My 1995 dodge ram 1500 takes a while to turn over
If I'm upstanding you your truck is cranking but not firing up.
So try this turn your key on but not all the way to start for 15 seconds do this 3 times then start it. If it start right away You may need a fuel pump. What I have seen is some fuel pumps have check valves that go bad and the pressure bleeds off. Always replace fuel filter at the same time.
Do you have any warning lights on after truck is started?
Keep in mine it takes a few seconds for lights to go out after engine is running that's okay.
If you do have any lights on after running take to a parts store that offers free check of your system.
Autozone is one but many will do this now.
Not finding what you are looking for?