Top 20 1995 Dodge Ram Questions & Answers


immobilizer , crank and cam position sensors have not being mentioned
dodge code 32 refers to faulty EGR and not to ignition problems
also if the ignition switch is faulty there will be no run circuit to provide power for the ignition in the run position

1995 Dodge Ram | 92 views | 0 helpful votes


Any time a seller says, "IT just needs this....." you should be suspicious. Get it checked out by a professional mechanic. Read this post

http://ricksfreeautorepairadvice.com/how-to-buy-a-used-car-part-iii/

1995 Dodge Ram | 24 views | 0 helpful votes


not really
people who interfere with auto electrics are a gold mine for auto electricians
best suggestion is to find the bad add-on that was installed and remove it
get the harness and electronics back to as near to original as possible so that problems are easier to fix

1995 Dodge Ram | 49 views | 0 helpful votes


hi you need a service manual which you can easily get from the reliable store here's the link
http://www.reliable-store.com/products/1995-dodge-ram-truck-1500-3500-service-repair-manual-download

1995 Dodge Ram | 139 views | 0 helpful votes


I guess the short answer is no.
It depends on the engine and trans, but the starter for a 1995 model 5.2 is different from a 2002 model with a 4.7 engine.

1995 Dodge Ram | 95 views | 0 helpful votes


Not sure what you are asking but it is not hard to replace the power steering pump just reinstall the same way you took it off. Just make sure to get all the air out of the system, to do that jack up the front to get the front wheels of the ground then with reservoir filled to correct height just turn the steering wheel from lock to lock what I mean by that is all the way to the right then all the way to the left. Have some one to look in the reservoir as you do this and watch for bubbles. When no more bubbles are present you have purged the system of air. Good luck.

1995 Dodge Ram | 75 views | 0 helpful votes


If you just replaced the battery or it went dead, it will need to relearn idle. If you push on and hold the accelerator down does it stay running?

1995 Dodge Ram | 56 views | 0 helpful votes


Scan for a fault in PCM then diagnose, probably related

1995 Dodge Ram | 47 views | 0 helpful votes


well not sure what style shifting it has. if its the floor shifter to select. you need to have the truck in neutral first before changing the 4wd. same thing with push button shifting on the newer trucks. it just works easier for the parts to move not being in gear. if it wont work with the shifter then you might have something that is broke or jammed.

1995 Dodge Ram | 124 views | 0 helpful votes


bbbind.com I saw a fuse box layout for your vehicle.

1995 Dodge Ram | 196 views | 0 helpful votes


What type or car or truck ,year Gas or Diesel .

1995 Dodge Ram | 31 views | 0 helpful votes


The entire frame and chassis of the vehicle is grounded via a heavy gauge cable from the (-) post of the battery. Various jumpers are used to ensure the (-) 12 volt side of the battery is present on body panels, framework, etc. throughout the vehicle.

The *best* place to connect electrically operated devices (audio especially) in the vehicle is AT the (+) & (-) battery posts - or as CLOSE to those points as practical. Doing so, will reduce the chances of objectionable "noise" being introduced to the radio on the power leads. This is especially true when trying to connect the ground or (-) lead(s) for equipment. "Dirty" power can actually be heard through speakers as static, hiss, popping, whine, etc. The battery is the cleanest source of power in the vehicle and should be used whenever clean power is essential.

1995 Dodge Ram | 67 views | 0 helpful votes


Don't try it is controlled by the computer all fuel injected engines idle and fuel controlled by the computer.

1995 Dodge Ram | 111 views | 0 helpful votes


You will need a short circuit finder tool and they are cheap. Then go to youtube and watch a video on finding a short circuit on autos.
There are too many possible issues to say what is the culprit. A second way to find what circuit is involved is to put inline fuses in every branching of that circuit.
A new sterio or amp install can also be responsible if such modifications were done recently.

1995 Dodge Ram | 56 views | 0 helpful votes


can you keep in running by power-braking it?
no mass vacuum leak?

1995 Dodge Ram | 40 views | 1 helpful votes


hi
was wondering if you could help me this is my ignition set up
c - blue wire a
s m - yellow wire
m - orange wire b
ive also got a purple wire that is coming from the choke, which letter would it got to..
also i connected the orange wire to m cause then the motor will start.
there is also a spare blue wire

HELP

1995 Dodge Ram | 229 views | 0 helpful votes


The pump relay gets power from two different fuses, then the engine computer grounds the relay to send power to the pump. Fuse 4 is hot all the time and fuse 9 is only hot when the key switch is on.
What part of the equation is not happening ?

1995 Dodge Ram | 29 views | 0 helpful votes

Not finding what you are looking for?
Cars & Trucks Logo

352 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Dodge Ram
1999 Dodge Ram

1,750 Questions

1994 Dodge Ram
1994 Dodge Ram

192 Questions

2004 Dodge Ram
2004 Dodge Ram

169 Questions

1998 Dodge Ram
1998 Dodge Ram

139 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ram Dodge

  • Ram Dodge

Most Popular Question

starts but loss power

  • Cars & Trucks
Loading...