Top 20
1995 Dodge Ram - Page 8 Questions & Answers
I just replaced the fuel pump in my 92 dodge ram
Did you replace fuel filter and why did you replace pump in the first place? Is there any junk in the gas tank? and did you flush the lines out? Also is the fue pressure regulator in working order?
1997 dodge ram 1500 5.9L getting hot
My best guess is your fan clutch has gone bad and your fan is slipping and turning too slow. I have a 1997 Dodge Ram 2500 van with the 5.9 liter engine and I just replaced my fan clutch a few days ago. It cost me about $60 since I did the work myself. If you plan on replacing it yourself I can give you fairly detailed instructions. Just post a comment here if you want the instructions and I will provide them in another comment.
Where should i start to look for a vacum leak in
everywhere on the engine intake area, use a can of carburator cleaner and spray around the top of the engine, u will hear a change in the engine sound and idle speed when u hit a vacuum leak.
What speakers fit in my 02 Ram Quad Cab?
In the front door, that's a factory 6x9 speaker. There are some aftermarket 6x9s that will fit. In the rear deck, they use a speaker similar to a 6 1/2 but the bolt pattern doesn't match up, so there are a number of 6 1/2 and 6 3/4 sized speakers that will fit, but you'll have to redrill the mounting screw holes.
Doesn't get fire since replacing fuel pump.
Normally after replacement of the fuel pump you need to get the fuel flowing back through the system again. To do this, turn the ignition key until you hear the fuel pump kick in for a few seconds, then turn key back to off. Repeat this several times to get the fuel flowing. If this doesn't help, you will need to ensure that the fuel pump is actually coming on. Let me know
Since repalacing fuel pump doesn't get fire
Take a look at the repair history. If you have fuel and you know the fuel is entering the cylinders then you need to find out why there isn't spark. Inspect spark plugs, wires, cap and rotor, then the coil, distributor, wiring, ignition switch, and ignition module.
What about my gas tank when the pump stops i can
when the gas gets to the top it rushes up while there is still air in the tank. once the fuel starts going down, it takes up the air space. its just a slow procedure for the air space to get taken up, thats all
Cannot find the code connector 1995 Ram 1500
The data link connector is a dedicated diagnostic scan tool connector. It is located in the engine compartment against the fire wall. It links the engine controller to the Diagnostic Readout Box (DRBII) scan tool or the Mopar Diagnostic System (MDS), or any other Chrysler-compatible diagnostic scan tool.
1995 dodge Ram odometer
Replaceing a sensor should not affect the spedo. It is ran directly from a switch on the side of the trans
1994 jeep cheokee
yo uhave a generic (unless you have an infinity sound system) speaker usually 6" round
How do you take fan off to get to water pump
A special fan tool is required to remove the fan from the water pump. Yes it does unscrew. One part of the tool holds the bolts of the pulley while the other part unscrews the large nut on the water pump. Tool rental is available at some auto parts stores.
Dodge ram odometer
Found out the end of the new sensor was not working correctly so replaced with another sensor. Thanks for the help
My 97 dodge pickup 318
first ... put a bottle or two of gas line antifreeze in the tank (it sucks up water in the fuel)... if that doesn't sort it out.... your coil pack may be dying
Not finding what you are looking for?