2004 Dodge Ram 3500 Truck - Page 9 - Answered Questions & Fixed issues
WHAT WOULD A P1690 MEAN?
None of the above. Stop looking for the most expensive comportment to replace first. This is a correlation issue.
P1690 Fuel injection pump ckp sensor dows no agree with ECM ckp sensor.
P1693 DTC detected in companion module
How to preform a regeneration on a 2008 6.7 dodge 3500 diesel
Have you tried doing a manual regen ? This is done by starting your vehicle, bringing your RPM to about 2500 and letting it run for about 20 minutes. If this does not work, might want to take your vehicle on a long drive in a lower gear and watching the temperature to reach slightly over normal operating temps. (190-210).
P done code dodge
IF YOUR TURNING THE KEY FOR CODES AND IT SAYS P-DONE ON THE BUILT IN OBDII READER IN YOUR CAR THEN THERE IS NO CODES FOR THE COMPUTER TO THROW AT YOU SO YOU SHOULD BE GOOD
2004 Dodge 3500 4x4 , torque converter lock up problems
The bad ground answer seems to be the most plausible answer. I had the same problem with my diesel 48RE transmission.I remembered a condition with the Intrepid where the instrument cluster lights and dome light would go nuts. The solution was to pull the plug from the back of the cluster dimmer control and apply electrolytic grease.I applied some to my Transmission Range Sensor connector and haven't had any trouble since.1. Diesels don't use vacuum2. Fluid level won't affect TC lockup3. Replaced the TC lockup solenoid array which did not alleviate the condition.UPDATE: The electrolytic paste in the plug did help for a time. However, eventually the torque converter failed about a year later and filled the transmission with metal filings :( I replaced it with a high-performance TC.
How do I replace heater core?
Remove heater box from under dash it should be in it ,check that there is no a plate screwed behind where the hoses go into the firewall.
Not finding what you are looking for?