Top 20 2002 Dodge Intrepid - Page 6 Questions & Answers

check to make sure the oil level is correct. if this is good and there is no engine noise then it could be the oil pressure switch has gone bad and needs replacing. if you have an engine noise then get the oil pressure check as you could have a bad oil pump or engine components worn out like bearings.

code p0700 refers to transmission control system malfunction==causes wiring-- TCM= replace the TCM . Check with the dealer to find which servo/ sensor p1818 refers to but it may also be related to the TCM.

Loose exhaust heat shield or possible a bad torque converter / trans input any codes

You may have a blown head gasket thatis pressurizing the coolant system-pull radiator cap off and put a pressure gauge on it and see if pressure goes above 17.5lbs-cheers Denny

is rpm at 4 means rpm at 4000. if so assuming everything is okey in the transmission. check your Vehicle Speed Sensor it looks like your not getting the signal which tells you computer to shift at overdrive when speed is over 50mph.

what your looking for is the petcock-which is the drain-its on the bottom of the radiator on one side or the other-cheers Denny

possible fuel pump failure or coil -coil pack bad - or timing belt needs replaced

probably not. It will allow the engine to move at idle and they are easy to check. IT the car shakes like the wheels are loose especially around 40-50 mph the you have a wheel alignment problem (Castor wobble). Have the front suspension checked and have a wheel alignment done.

sounds to me like the ejector spring is broken and the motors burned out time for another one

Replace your alternator.

next to the oil filter on right side of engine

check wheel bearings for condition and adjustment

This is most likely the ac belt either bad or loose on the pulleys. This could also be the blower motor which would cause you to lose all AC if it goes completely out.

Possibly lost one of the balance weights from a tire.... or you have a bad bearing on the drive shaft U joint.Depends on how fast you are going.....Jim

did the steering suddenly become very hard to steer, as in no power assist? I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

you may have a faulty temp sender or cap, sounds like you are boiling it over, very easy on these cars without the proper functioning cap.

see the diagram attached. God bless you

that just tells you the directin of flow

Vacuum leak? spark plugs?

It sounds like your multi funcion switch is faulty