20 Most Recent
2004 Dodge Neon - Page 5 Questions & Answers
How to reset immobiliser
Using the VIN # A dealer can make a new key for the original ignition for cars up to ten years old. To make a replacement work You need the transponder from the replacement ignition setup
What is making my motor drag
Fuel is metered based on a signal the computer gets from the coolant temperature sensor. Over heating may have damaged it. If the wire connection is good the sensor may be bad, Change the sensor. It is very close to the thermostat (19MM deep well socket needed)
I replaced the fuel pump in my 2004 dodge neon and
There is a wire grounding out somewhere. Start from the fuel pump (u know that is good) and follow the wires inspecting them carefully for any chafing or corrosion. It should go up thru the floor around the back of the back seat. Pop the seat out and continue looking at the wires taking the wrapping off as you go. It may be bad under the carpet where water collects from boots and shoes, so look at these areas carefully for corrosion. Happy hunting!!
What to remove to replace timing belt 2004 dodge neon sxt
There are many things that must be done to replace a timing belt. It is not possible in this forum to list them nor give an adequate step-by-step instructional for this job. On many cars the only job harder than a timing belt is a full engine overhaul. If you really want to do this and you feel you have the skill set to pull it off, invest in the Haynes or Chiltons manual for the vehicle and follow their instructions. Be advised though, if you are biting off more than you can chew, you will end up costing yourself much more than you may have saved by doing it yourself....possibly with the loss of the vehicle's engine to boot.
P0700 code 2004 dodge neon sxt
Generic code for transmission failures. This one covers all of them.. Have the codes read from other than a parts store.
Diagram sensors
They're all on the exhaust system. Just trace them from the exhaust manifold down the pipe to about the middle of the car.
My van has 3 of these.
Programming keyless remote for Neon 2004
There is a way to program a remote if there is already a valid remote. Unfortunatly if you don't have a valid remote the only way to get one programmed is at the dealership with their scan tool.
I have pasted directions for programming a remote if there is already a valid transmiter.
CUSTOMER PROGRAMMING
For a customer to be able to program RKE transmitters themselves, at least one RKE transmitter must be programmed already. This procedure is to add additional transmitters. If all transmitters are lost, the DRB III® scan tool must be used to program the new transmitters.
- Insert the key into the ignition switch, and turn the ignition switch to the RUN position without starting the vehicle (allow chimes to stop).
- Using the RKE transmitter programmed to the RKE module, press and continuously hold down the UNLOCK button for 4-10 seconds.
- Within the 4-10 second time range, continue to hold the UNLOCK button and press the PANIC button. Both buttons may then be released. Upon the PANIC button being depressed, the message for customer programming mode will be transmitted to the RKE module.
- A chime will be heard to verify that the customer programming mode has been entered (allow 3 seconds to hear chimes).
- Press and release any button on each transmitter that is to be programmed to the RKE module, including any transmitters which were previously programmed to the RKE module (with a maximum of four possible). After each transmitter is successfully programmed, a chime will be heard to verify that successful programming of the transmitter has occurred.
- After thirty seconds, or upon the ignition switch being turned OFF, the RKE module will exit programming mode.
Not finding what you are looking for?