Top 20
2004 Dodge Neon Questions & Answers
1 Answer
I have a 2004 dodge neon 2.0 it shakes when the
You should check the engine mounts again. Make sure you have the motion dampeners on between the engine and the mounts. Basically it's the rubber spacer you should have put on between the two to dampen the vibration of the engine to the mount. At least thats what it sounds like to me.
2004 Dodge Neon
|
45 views | 0 helpful votes
1 Answer
Codes are: P0700
Moisture has gotten into some electrical connectors when the heater core was replaced. These electronic transmissions have speed sensors and electrical connectors that do not like moisture in them. disconnect any connectors that may have gotten wet. Blow them out with compressed air. Good luck.
2004 Dodge Neon
|
299 views | 0 helpful votes
1 Answer
I am getting a p2074 code off my obd11 reader for my 2004 dodge neon sxt 2.0 l engine and a fuse light on my dash is blinking.
Not sure what the fuse light means, but you can localize the vacuum leak by going around the intake manifold and plugging off any ports. For example, the purge line can be taken off. Put your finger over the port to see if the engine idles down. If yes, trace the purge line back to the solenoid valve to find the leak. Similarly, you can remove the brake booster line and plug that port. If plugging the ports does not bring the idle down, next check the gaskets. Try spraying some carb cleaner on the gaskets while ybe engine idles. If the speed changes, uou have a gasket leak.
2004 Dodge Neon
|
86 views | 0 helpful votes
1 Answer
P0700 code - Transmission control module. When should I know for sure to replace.
code p 0700 refers to transmission control system/MIL---malfunction====causes---wiring---TCM
you may have to have the replacement tcm checked out as you may have replaced a faulty unit with a faulty unit
check the wires and harness connections ( pins corroded , loose broken wiring at both ends including the connector at the ECM)
Other than that , take it to an accredited transmission specialist shop and have the system checked and diagnosed
2004 Dodge Neon
|
204 views | 0 helpful votes
2 Answers
Over night the battery is dead
Put a 12v test light between the positive terminal and the battery cable.If the light is bright the draw is to much.A dim light is fine.if the light is bright,plug one fuse at a time until light dims.DO NOT cause a draw by leaving a door open etc while testing.DO NOT try and start the car or turn the key on during this test.Once you have found the fuse that causes the most draw,if you want to save $ you can just pull this fuse overnight or wire that circuit with a relay to unpower it when the vehicle is switched off.
2004 Dodge Neon
|
196 views | 0 helpful votes
1 Answer
I have a 2004 dodge
If u have an exhaust leak (loud sound) that will affect a lot of the sensor readings. The O2 sensors will not read properly either & set codes. If the leak is large enough u will lose power & the trans wont work properly either & set codes. Just because u have a code, doesn't mean the part is bad. Start w the basics. If there is an exhaust leak, fix that 1st & clear the codes.
2004 Dodge Neon
|
210 views | 0 helpful votes
Not finding what you are looking for?
