Top 20
2004 Dodge Neon - Page 9 Questions & Answers
Idle drops way down in drive gear in park it's fine or running the A/C
what car is this, could be normal or not depending, like my 73 nova dogs down when put in gear but its suppose to with a 3 speed turbo. if its a newer car its not. and would sudject checking transmission fluid/filter or even replace both. if your fuild is low or old the transmission wont slip as easy and will make you car work harder to idel while sitting still.
Reverse lights do not work
Try changing the bulbs, but if you have already done that then check out the fuse box. lights have different amps marked on them and plus it should be written on the fuse diagram in the box.......hope it helps
Can't get battery tray out
some of the dodges have holes and slots that hold the box in place as well, try sliding it sideways either forward or back, side to side.
Brakes
kink in the line?blockage in line?leak in the slave cylinder?Jammed piston?
2007 mazda5 AT stuck in park
MOST CARS WOILL NOT SHIFT FROM PARK IF THE BRAKE PETAL HAS BEEN PUSHED DOWN TO ENGAGE SWITCH.SWITCH IS BROKEN OR NOT CONTACTING.
Where is the started located on a 2004 dodge neon
I do not know the EXACT location, but can give you an idea of where to look. Most starters are on the 'right' side of the engine, mounted to the transmission. To determine what I mean by the right side, stand at the transmission side of the engine facing it, the belts should be on the other side of the car from you. Your right is the engine's right. If the belts are near the passenger fender, the starter should be under the manifold up against the firewall, bolted to the transmission. If it isn't there, then check the left side, as cramped engine compartments can cause the manufacturer to deviate from the 'norm'.
Price of a camshift position sensor
Hi there:In this link can see
Camshaft Position Sensor replacement around US$ 20.00
Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.
What does a clutch pedal position switch do?
It tells the Powertrain Control Module (PCM) what position your clutch pedal is in (pretty much like the name implies). The PCM will not allow the starter to work unless the clutch pedal is in the down position. The purpose is to keep you from starting the engine with the clutch engaged so the vehicle doesn't jump forward and kill somebody when you twist the key.
#15 fuse in my 2004 keeps blowing as soon as I put
This means there is a dead short on that circuit. You can fix this several ways. Get a chassis wiring diagram through autozone.com for free by registering your vehicle. Then look at which systems that fuse operates.Go to the item that is connected and unplug it. If you now put a test light in the fuse slots, it should not be connected without that item. The wiring is grounded between the item and the fuse panel if the test light lights up. If the test light stays off, then the wiring is okay. The part you disconnected needs to be tested for grounding.If you find that the wiring is carrying a current when it is not connected, then it has bad isulation and the exposed part needs fixing or replacing.Change over to an Ohmmeter and disconnect the power. You should have continuity in the bad wire, then repair the wire so it does not provide continuity.Remove the Ohmmeter, restore power and replace the fuse and it should work.
Radio shuts off while engine running
check to see if you get power at radio power wire if not it may be a problem with your ignition does every thing else work when car is running?
Not finding what you are looking for?