1988 Dodge Ram Wagon - Answered Questions & Fixed issues
How do I adjust the steering gearbox?
dodge vans equipped with a saginaw gearbox and the adjustment is shown in this video http://www.youtube.com/watch?feature=player_detailpage&v=XjOYQcRx_hc this is from a dakota but the procedure is the same
My 1988 dodge ram custom 50 I think is having fuel
There are fuel lines inside the gas tank. Over time they can rust causing them to break or leak. You have one of two options, first you can pull the tank and replace the line. The second option is to keep the gas tank fuel level above the leak. And the fact that this happens mainly when going up a hill, suggests the leak is lower in the tank. All the gas shifts to the rear of the tank and exposes the leak. NOTE: The leak is probably just above the level you usually keep the tank filled to. So if you keep it at 1/4 that's where you'll find it etc....
Should i buy a 1988 ram pick up
hmmm.....very good question...
things to check
engine how many miles does it have?
how many miles per gallon?
is the frame in good shape?
is it rusty?
/////etc......etc.....***
it is really up to you.......
i know that it has 170 horses......"5.9L V8......i would buy it....XD...
good luck on ur decision....XD!
How come why my 98 Dodge ram starts and runs fine but when I switch it off it won't start back up
no ca/truckr model told at all, of many 3 or 4.no engine told and is and engine problem.the VIN digit #8 is the engine codeNO model told.ram 1500 ?, 2500, 3500 or 4000 , and not the Ram van. 1998 (4000 Mexico or Canada)no engine told one is Diesel;, 3.9 L Magnum V65.2 L Magnum V85.9 L Magnum V85.9 L Cummins turbo-diesel I6<<< ill not cover this ever.8.0 L Magnum V10does the starter motor always work correctly every time, called cranking?we get the fact it does not start. sometimesbut what is not clear, at all, is that the starter always makes this sound called cranking? or fails to do crankingsee MP3 post
I have a 2012 Dodge Ram.. I Keep trying and eventually it starts. I have replaced the fuel pump, spark plugs, and fuel relay. Once it gets started and warms up then I have no trouble starting it.
If you're experiencing difficulty starting your 2012 Dodge Ram, even after replacing the fuel pump, spark plugs, and fuel relay, there may be several other possible causes. Here are a few things you can check:
- Check the Battery: A weak battery can cause starting issues, especially in colder temperatures. Check the battery voltage and consider replacing the battery if it's not holding a charge or is more than a few years old.
- Inspect the Ignition System: The ignition system includes the spark plugs, ignition coils, and spark plug wires. If any of these components are worn, damaged, or corroded, it could cause starting problems. Check these components and replace them as necessary.
- Check the Fuel System: While you've already replaced the fuel pump and fuel relay, it's possible that there is still an issue with the fuel system. Check the fuel pressure to make sure it's within the manufacturer's specifications. If it's too low, there could be a problem with the fuel filter or fuel injectors.
- Check the Engine Coolant Temperature Sensor: The engine coolant temperature sensor can affect the fuel system and cause starting problems if it's faulty or not reading the engine temperature correctly. Check this sensor and replace it if necessary.
- Check the Starter Motor: The starter motor could be failing or not engaging properly, which could cause starting problems. Check the starter motor and have it tested if necessary.
If none of these suggestions resolves the issue, it's recommended to take your vehicle to a certified mechanic or dealership for further diagnosis and repair.
2002 Ram Cummins A/C Compressor On/Off
Your A/C system have safety switches, IE-limit switches. You could have either low or high pressure kicking out your compressor. You need a set of gauges to tell what your issue is.
Red lightning bolt on 2008 Dodge Ram 5.7 hemi truck won't start, drove it to the vets came out and nothing...
The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. Get a code reader and scan the engine for any logged codes. The light may be on for a glitch and the electronic throttle control system needs to be reset.
To reset the Dodge Ram throttle position sensor(TPS), You need to turn on the ignition without Your foot on the brake, so the engine doesn't start. Then press the accelerator on the floor for 15 seconds. Release the accelerator. Then turn the car off and start the engine and drive.
Not finding what you are looking for?