1995 Dodge Ram 2500 - Answered Questions & Fixed issues


LOOK AT TIRE STICKER / LABEL ON EDGE OF DRIVER'S DOOR OR DOOR FRAME.. READ ACTUAL PRINTING ON EACH TIRE TO CONFIRM THEY ARE CORRECT SIZE AND HAVE SAME SPEED RATING. INFLATE TIRE PRESSURES TO PSI ON LABEL OR ONE PSI HIGHER.

HAD SIMILAR FRONT END WORK AND MY VEHICLE
DARN THING PULLED RIGHT AND STEERING WHEEL WAS LIKE YOURS. FRESH ALIGNMENT CURED ALL.

EVEN IF YOU DIDN'T HIT CURB OR POT HOLE, YOU NEED A FRESH ALIGNMENT MECHANICS SHOULD ALWAYS CENTRE STEERING WHEELS AND ONLY THEN ADJUST FOR ALIGNMENT.

1995 Dodge Ram... | Answered on Sep 21, 2018 | 1,039 views


Injector pump is the most likely cause and they are not cheap.

1995 Dodge Ram... | Answered on Aug 15, 2017 | 53 views


There should probably be a relay for them too.

1995 Dodge Ram... | Answered on May 09, 2017 | 142 views


P1D73 is active grille shutters

1995 Dodge Ram... | Answered on Apr 09, 2017 | 77 views


1995 Dodge Ram 2500
Left Front Speaker Positive Wire (+): Dark Green
Left Front Speaker Negative Wire (-): Brown/Red
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Dark Blue/Red
Left Rear Speaker Positive Wire (+): Brown/Yellow
Left Rear Speaker Negative Wire (-): Brown/Light Blue
Right Rear Speaker Positive Wire (+): Dark Blue/White
Right Rear Speaker Negative Wire (-): Dark Blue/Orange

1995 Dodge Ram... | Answered on Feb 16, 2017 | 325 views


The only way to know if you need engine repair or you have a bad sender is to hook up an oil pressure test gage to the sender port and manually check the pressure. You will need the deep oil pressure sending unit removal tool to get the sender out (I did this).

1995 Dodge Ram... | Answered on Nov 09, 2016 | 73 views


I strongly doubt that the fuel pressure is related to your oil pump. More likely fuel pump or fuel filter. Fuel pumps do go bad, and is likely located in your gas tank. I would replace fuel filter first, and if that doesn't help, then check the pressure itself before replacing the pump.

1995 Dodge Ram... | Answered on Nov 09, 2016 | 26 views


8.0 Liter engine is 35 to 45 lbs. for 1995.

If you need further help, reach me via phone at https://www.6ya.com/expert/daniel_4061c3d97c12c4c7

1995 Dodge Ram... | Answered on Sep 23, 2015 | 877 views


if it is EFI then use a scan tool to reset the ECM program

1995 Dodge Ram... | Answered on Sep 12, 2015 | 84 views


Does it immediaetely restart once it dies or do you have to crank it for a bit? You have to determine whether fuel supply or spark supply is causing the issue

1995 Dodge Ram... | Answered on Apr 26, 2015 | 79 views


read it on the tire different sizes use different pressures

1995 Dodge Ram... | Answered on Mar 11, 2015 | 17 views


drain the rad into a pail.
remove the upper rad hose from the thermostat housing.
remove the thermostat housing
remove the gasket/seal (from housing or engine)
remove thermostat

install ne stat & gasket/seal
reinstall housing and hose.

close off rad bottom valve
refill rad with new coolant (with cap off run engine until warm
top up fluid to neck) replace cap.

dispose of old fluid at environmental recycle center

1995 Dodge Ram... | Answered on Feb 17, 2015 | 261 views


coil might be bad check for spark

1995 Dodge Ram... | Answered on Feb 09, 2015 | 37 views


Just replace the pull out head light switch that should be what's causing that my 97 was doing the same thing and it's easy to remove and install

1995 Dodge Ram... | Answered on Jan 11, 2015 | 107 views


Find yourself a copy of both wiring diagrams and overlay one on the other in effect. Working out whats missing. Is it that difficult to get the right harness? Given the age I'd have thought there were junk yard offerings?

1995 Dodge Ram... | Answered on Nov 18, 2014 | 126 views


You don't bleed these. They are part of the system. Bleed the brakes normally.

1995 Dodge Ram... | Answered on Nov 12, 2014 | 205 views


Hey Steve, if image below wont open please go to autozone library it there,

1995 Dodge Ram... | Answered on Oct 31, 2014 | 599 views


did you try a pick-a-part junkyard ?

They have old wrecked cars, you go there tell'em what you need, they quote you a price, (pay a nominal fee to get in usually,) then you go and walk the lot looking for your car, and see if it still has an undamaged front seat. You have to dis-assemble and remove the part yourself. Usually there are no refunds if you install it and it does not work, so with electronic parts you take a bit of a risk.

the next time anything major fails on my '99 Grand Prix I will likely have to do the same.

1995 Dodge Ram... | Answered on Oct 31, 2014 | 28 views


suspect the blower motor or resistor

1995 Dodge Ram... | Answered on Oct 26, 2014 | 29 views

Not finding what you are looking for?
Cars & Trucks Logo

334 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...