20 Most Recent 1998 Dodge Ram 3500 2WD Questions & Answers

Short shoe on the front long shoe on the back. Drum style brakes are self energizing. When the wheel cylinder pushes the shoes out, the front shoe tries to spin with the drum, which pushes on the adjuster, pressing on the rear shoe. So the rear shoe is pushed into the drum by the wheel cyl, and the front shoe.

P0216 - injector timing control circuit

P0234 - turbo / supercharger over boost condition

P0523 - engine oil pressure sensor / switch circuit high inout.

you don't repair it on this engine u replace it. the repair requires the removal of the engine

Is headlamp connector a three wire connector? One should be voltage, hot all the time, use a digital multimeter to check for voltage. The others should be ground. Your dimmer and headlamp switch are on the ground circuit. One way to check ground would be to use a redundant ground jumper wire, If the lamp then works correctly, the problem is ground. Hopefully you can bypass switches to rule them in or out. If you bypass switch and lamp works correctly, then the switch is faulty. Just my opinion.

master

its on the back of the fuse box cover that snaps in the side of the dash

Usually a diagram under the hood

When the key is turned to the start position, the pump should run for about 20 seconds. Do this 3 or 4 times to prime the pump.

If it still doesn't start, the bad lift pump may have damaged the injection pump. Crack a fuel line loose (don't remove it) and turn the engine over, you should have fuel at the fitting.

git started?! or go to the local junk-yard and git anther 1. is the question HOW TO DO THIS? or what? lol.

Your brakes are telling you they require service. Please take your car in for important brake service.

Thank you for your interest in FixYa.com

1998 4wd club cab, same problem, found 2"x2" box the seat belts are pluged into luckgood under the middle of the front seat, gave it a good tap and I'am good to go.

there should be no air in the cooling system and the system can be bled by using a pressurising equipment . Ensure that the thermostat is placed in the motor the right way with the body facing the hot water (head or block). Air defeats the purpose of having a pressurised cap and system.