20 Most Recent 1999 Dodge Ram Questions & Answers


I cannot see how one bolt missing from the transmission would make a difference in shifting.Did you check the fluid? After the car has been driven your fluid level should be at the FULL mark.Not above it, or below it. Also,if your replacement trans came from a bone yard, That could be the problem".Most junk yards offer a warranty for a few dollars."

1999 Dodge Ram | Answered on Nov 10, 2019


Hi, the problem you are having sounds like the differential needs replacing this can be expensive and hard work but not doing this can cause further damage to your vehicle so its better get it done sooner rather than later.
If on the other hand your only getting a vibration through the steering wheel then this could be that the wheels need balancing.
You should know which of the two problems you have if you need further assistance then just let me know ok

1999 Dodge Ram | Answered on Jun 02, 2019


could be the ignition switch. It's definitely an electrical problem, and the ignition switch is the most likely cause.

1999 Dodge Ram | Answered on Feb 13, 2019


It's the IOD fuse. Trust me, I just fixed the exact problem on my '98 not ten minutes ago. The fuse is located in the fuse box inside the driver's side door. It will be the fuse on the bottom and toward the front of the panel with a black cover over it. Just pull the fuse holder straight out and snap the hinged cover forward to expose the fuse. Just a standard 10 amp automotive fuse and you're back in business!

Wes

1999 Dodge Ram | Answered on May 23, 2018


If you're comfy
with manuals then i know few websites that can help you with it. Bcause I've bought it from various websites so I know how each site deals. try www.reliable-store.com
Very helpful

1999 Dodge Ram | Answered on Mar 11, 2018


I think you could use this manual method instead.. My nephew used it
to repair my car and it's totally perfectly fine now. Here's the website he bought it from. www.reliable-store.com

1999 Dodge Ram | Answered on Mar 07, 2018


If your pump was dropping pressure, I would expect a rattly engine and it is rare to recover. Check the pressure sensor and wiring.

1999 Dodge Ram | Answered on Feb 04, 2018


When was the last time you had the transmission serviced,
the oil and filter, it should be changed. if you have had that done then take your car to AMCO transmission shop, they probably wouldn't charge anything to check your car.

1999 Dodge Ram | Answered on Feb 04, 2018


Maybe your belt tensioner is locked up ? See if it's turning

1999 Dodge Ram | Answered on Feb 04, 2018


have you checked the fuse

1999 Dodge Ram | Answered on Feb 04, 2018


yuck had elec problems take for ever to run through harness but that is what you have to do wire by wire testing for drops and if it doesnt happen when testing you will have to do it againg n again but in process clean and check connectors also

1999 Dodge Ram | Answered on Feb 03, 2018


I hope that you have disconnected the battery fire could happen relay click's but will stick at drain could be the fuel pump you hear with the continuse click you might have a shorted starter.I think thats the first place to start.A bad ignition switch will cause this to happen sometimes?

1999 Dodge Ram | Answered on Jan 12, 2018


The cluster work from 2 wires can bus a lot of times is the sensor ground not connected.

1999 Dodge Ram | Answered on Jan 10, 2018


The fuel transfer pump is controlled by the ECM.

1999 Dodge Ram | Answered on Nov 01, 2017


My dad has a 96 Ram Cummings and he ended up changing a relay on the fire wall. There are two of them beside each other. If you turn your key on and go under the hood on the drivers side push up the linkage on the bottom of the actuator it should stay in place now go inside and see if it will start. That actuator has to be up or it won't start if it's not going up when you turn the key on it's that relay on the driver side firewall.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/benjamin_494963e790f97efb

1999 Dodge Ram | Answered on Nov 01, 2017


there is a fuse by the rear blower motor i found an intermitant connection. Changing fuse holder fixed it

1999 Dodge Ram | Answered on Oct 30, 2017


check the wiring to the crank/cam position sensors or replace as required

1999 Dodge Ram | Answered on Oct 09, 2017


Should be on the valve cover.
0996b43f8021b563-lgd0on5kwttmxgdtmabjr2fz-1-0.gif

1999 Dodge Ram | Answered on Sep 23, 2017

Not finding what you are looking for?
1999 Dodge Ram Logo

2,533 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1994 Dodge Ram
1994 Dodge Ram

192 Questions

2004 Dodge Ram
2004 Dodge Ram

170 Questions

1998 Dodge Ram
1998 Dodge Ram

139 Questions

1990 Dodge Ram
1990 Dodge Ram

113 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ram Dodge

  • Ram Dodge

Most Popular Question

99 dodge ram recently changed

  • Cars & Trucks
Loading...