1994 Ford Taurus - Answered Questions & Fixed issues
Change spark plugs and now car wont start.....1994 ford tarus
Do you have the "firing order" correct? In other words, is each spark plug wire going to the same cylinder it was on before you changed the plugs? If you have done nothing else but changed the plugs then this is the most likely problem.
If when you try to start the car it backfires through the exhaust or backfires through the intake. Then this " IS" the problem. Good luck.
CAR WONT START ON FORD FALCON AU (AUTO)
Check the voltage on your battery. When the battery is low, you will still have lights and what not but not enough juice to start the car. Check the condition of your battery cables especially your ground. If everything check out fine, your problem may be a bad starter or the solenoid. If you replace the starter, replace the solenoid with it. Be sure to check the cable from the starter solenoid to the starter.
6/16/2019 9:51:31 AM •
1994 Ford Taurus
•
Answered
on Jun 16, 2019
•
2,248 views
Why distributer drive gear lays done
check the drive system for the distributor
ford employ a shaft that drives the oil pump and if the oil pump is under undue stress, it strips the gear or breaks a shear pin
all the gear is driving is a distributor shaft and in the first instance could be a seized bush for the shaft but with replacements failing I would be looking further afield , like an oil pump
Where is headlight relay located?
Does the vehicle have auto lamps ? There would only be a relay if the vehicle had auto lamps ! An does it happen in auto or regular headlamps ?
I have a 1994 ford Taurus that has new plugs new thermastat new water pump new coil wires but car is still overheating
does putting heater on hot prduce hot air.on full with fan on does it reduce temo?is ur radiator fan coming on? hard to give one answer.as dont know if its overheating in traffic or on the move?there could be air stuck in pipes slowing water flow.or a pipe/radiator blockage so coolant doesnt get to flow around engine so it gets hot.u could check radiator by touching see if hot or cold where pipes enter(prob switch off engine first) try bleeding system squeesing pipes to push air out
Not finding what you are looking for?