20 Most Recent
1998 Ford F150 Regular Cab - Page 8 Questions & Answers
Keyless remotes not working
Try reprogramming the remotes. Here are the instructions for the procedure. Hope it helps. Cobra!
Programming
NOTE: All keyless entry remote transmitters (15K601) must be
programmed at the same time.
NOTE: To program (or reprogram) the keyless entry remote transmitters
into the RAP module, perform the following steps:
- Make sure that the anti-theft system is not armed or triggered.
- Turn the ignition switch (11572) from OFF to RUN eight times within ten
seconds, ending in RUN. If the RAP module has successfully entered program mode,
it will lock and then unlock all doors.
- Within 20 seconds, press any button on a keyless entry remote transmitter,
and the doors will lock and then unlock to confirm that each keyless entry
remote transmitter has been programmed. Repeat this step for each
transmitter.
- If the door locks do not respond for any keyless entry remote transmitter,
wait several seconds and press the button again. If the door locks still fail to
respond, refer to Inspection and Verification.
- Turn the ignition switch to the OFF position, or wait up to 20 seconds after
step 2, to exit program mode. If a keyless entry remote transmitter has been
programmed (or reprogrammed), the RAP module will lock and unlock all doors one
last time to confirm.
Brake master cylinder
Someyimes if the MC. level gets too low, air bubbles can get trapped in the hydraulic control unit for the ABS. and it won't matter how much you bleed the brakes, that bubble will b stuck and will cause spongy/no pedal. it this happens, only way to get it out is ABS service bleed with a professional scan tool (ones at oreilys won't cut it) to cycle the valves then re bleed system. most shops charge under $150 for this...worth a shot
Po713
P0713 FORD - Transmission Fluid Temperature Sensor 'A' High InputPossible causes - Faulty Transmission Fluid Temperature Sensor- Transmission Fluid Temperature Sensor harness is open or shorted- Transmission Fluid Temperature Sensor circuit poor electrical connection
How do you test fuses
Some fuses have it where you can see the wire inside,if not broken,then fuse is good,if fuse has nothing to see,then you can get a meter and it will beep if good.Or you can take to Autozone,they will test for free,cheaper than buying a meter.
Electric window won't roll down
It's not a worm gear,just a small gear on the motor and a longmetal gear an the regulator. They are riveted in,if the door panelcracked or a rivet came loose the gears may have slipped,have topull the door panel to see.
Not finding what you are looking for?