20 Most Recent 2000 Nissan Frontier - Page 8 Questions & Answers

your feeling what Nissan refers to as limp mode (also known as fail safe ) Nissan computer strategy is when its detects a computer sensor (that could cause engine damage)has failed,or your engine for any other reason is running in a way that could cause severe engine damage is to make your engine run at limited rpm until the concern is repaired,I would assume your check engine light must be on, if not the bulb in the dash may be bad, anyways the best route is to have the engine control module scan for trouble codes which will get you headed in the right direction.

Check your Fuse, Did you have the KEY on? It will only power for 2-3 seconds....

Here's a link to your belts.

Hi Wayne,here's a link on how to clean your egr valve.

You need a better scanner

Sounds like multi-function/ turn signal switch

Nissan markets its D22 and D40 pickup trucks in North America as the Frontier. A six-cylinder 3.3-liter engine with a double overhead camshaft is standard for the D22 models. The timing belt for this engine keeps the camshafts synchronized with the camshaft, enabling the engine to run smoothly. The timing belt has a limited lifetime, and typically requires replacement after 60,000 miles.----------------------------------------------------------------------------------------------Original Launch CResetter

Some say 80000,but I would say 60000,

The code is for random missfire.Chances are you are getting water inside the distributor cap or the plug wires are shorting out when they are wet.

to check the feul pump. have some one in the back and turn the key to the start position and if you hear a buzzing noise the pump work. if you do not hear a buzzing from the gas tank. you need to chech relays

PO 304-- is a misfire in cylinder # 4You can Google any codes you getPCV Valve- if you knew what one was,has to be on the valve cover, to keepoil in the crankcase from entering theinduction system