2002 Ford Windstar Cargo - Answered Questions & Fixed issues
Ford windstar won't reverse
Has the automatic transmission fluid and filter been changed. A flush and change is worth a try.
12/24/2020 12:58:27 PM •
2002 Ford...
•
Answered
on Dec 24, 2020
•
834 views
2002 Windstar wont go into gear
These are common for the pump shaft splines stripping in the torque converter. The transmission will need to be removed to fix it. Before you condemn the trans, does the speedo move and the van doesn't or do you hear any grinding when you put it back into park? Or can you push the van in park (Broken CV shafts)?
8/29/2018 9:56:07 PM •
2002 Ford...
•
Answered
on Aug 29, 2018
•
579 views
Ford windstar 2002 problems
First,open the hood and at the back left (your left) you will see a large wire harness attached to a computer.Remove the computer connections and clean them with "contact clean".Reinstall the connections and waterproof this area,as Ford did not and these connections are famous for corrosion.Chances are now your Windstar will run better than ever now.
3/2/2018 9:59:27 PM •
2002 Ford...
•
Answered
on Mar 02, 2018
•
148 views
I need a diagram for
Moving only one way is usually the sign of a bad switch or a wiring issue, not the regulator/motor. It's usually the master switch that goes bad since it's used most often. You can't bypass it because the power and ground both run through it.
10/19/2017 9:02:10 PM •
2002 Ford...
•
Answered
on Oct 19, 2017
•
173 views
Transnission troubles 2002 Windstari
Buster, check the transmission fluid level, if level OK it is something wrong internal of transmission,torque converter,pump,shaft splines stripped,etc. Take into a good shop for diagnosis and estimate to repair/replace.Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Ford Windstar transmission problem
windstar transmission
2003 windstar transmission wont move into any gear
6/2/2016 2:11:42 PM •
2002 Ford...
•
Answered
on Jun 02, 2016
•
284 views
Horn does not work
might be broken contacts on the horn button on the steering wheel. that's where my problem was.
1/9/2016 7:43:34 AM •
2002 Ford...
•
Answered
on Jan 09, 2016
•
130 views
Engine is hot and the cooling fan are working
sounds like thermostat not workin right or BLOCK OR THE HEADS problems right away HOT ?Sounds Bad Let Me Know Get It tested For Pressure right Away Please So YA Know What,s Up with it
3/6/2015 6:59:17 AM •
2002 Ford...
•
Answered
on Mar 06, 2015
•
101 views
Trans won't shift to second gear
ok sounds Like the Coil Pack is goin when it get,s Hot So rep[lace It And Sounds Like Solenoid or the Filter in the Tranny TAke it too them Ask Them Nicely on what to do to it Please Remember Please
3/6/2015 6:22:57 AM •
2002 Ford...
•
Answered
on Mar 06, 2015
•
75 views
Where is the unlock code on 2002 windstar keyless entry
Usually kept in several places. One is in owners manual, another is behind storage doors (small doors in cargo area with jack and rear washer storage) or on back of spare tire area in back compartment. Look for a sticker on back side of spare tire cover, or in front or rear of owners manual etc. It sometimes is just a sticker with 5 numbers on it and says nothing else. If all else fails you can usually have dealer look it up if you bring paper to them showing you own vehicle. The manual tells you how to add your own number to also work with system - but if battery unhooked for long enough it will go back to just remembering factory code.
1/18/2015 1:48:47 AM •
2002 Ford...
•
Answered
on Jan 18, 2015
•
961 views
How do I get the auto theft light on my 2002ford windstar to go off?
Make sure battery is strong and try leaving key in on position for 5 to 15 minutes. Then go to start. This works on many vehicles - but many are different. If chip key and theft module working leaving key on for several minutes is supposed to be long enough to tell system vehicle is not being stolen (not many thieves willing to sit in car waiting for 10 minutes). If chip key or key "reader" has failed you need dealer help.
1/14/2015 1:56:10 PM •
2002 Ford...
•
Answered
on Jan 14, 2015
•
177 views
Why does my 2002 Ford Windstar se idle at 3000
The mass air flow sensor, the throttle body and the idle air control motor need a good cleaning. Use a brush and brake clean everything except the Mass air flow sensor, just spray it down, both sides. After you clean it, it will take a few second to restart.
11/3/2014 11:57:35 PM •
2002 Ford...
•
Answered
on Nov 03, 2014
•
237 views
No connection of OBD port
What do you mean it wont connect, it plugs in right?
it wont power up???? I'll bet the cigarette lighter is also dead, replace the lighter fuse
10/31/2014 1:16:58 AM •
2002 Ford...
•
Answered
on Oct 31, 2014
•
445 views
Not finding what you are looking for?