20 Most Recent 1996 Ford Ranger SuperCab - Page 4 Questions & Answers


I would say it is your clutch (In your case it more than likely the throw out bearing if you hear rattle sound.) with the amount of miles and the year of the vehicle. Clutch plates, just like brake pads, eventually wear out. Consider yourself fortunate that you have gone this far without having to replace it.

1996 Ford Ranger... | Answered on Sep 06, 2013


I found out with my old 94 Ranger 2.3L that the oil breather does not have a filter element, which causes oil to "naturally" (as Ford puts it) accumulate in the throttle body and air intake hose. You can get an inline breather element at any parts store for a few bucks and install it on the breather line without harming anything, and this will stop. Cheers.

1996 Ford Ranger... | Answered on Jul 15, 2013


The most common cause is too much pressure in the crankcase. It could be bad piston rings, or a problem with the PCV system. The engine is supposed to draw fumes from the crankcase into the intake and burn them, but the intake may be getting real oil instead of just fumes.

1996 Ford Ranger... | Answered on Jul 15, 2013


its due to low/no fluid level in the power steering reservoir.Check the fluid in the power steering. If it is low the car will make noise when you turn the wheel. the internal parts gets rubbed hard and noise occurs. refill the fluid and let it reset for some time then try it will get the fluency to move smooth and noise will get stopped. -------- This will help. Thanks please keep updated.please do rate the solution if helped.thank you for using fixya.

1996 Ford Ranger... | Answered on Jul 10, 2013


Did you check fuses under hood as well? You may want to check if power is getting to the headlight switch. That controls all the lights that quit working.

1996 Ford Ranger... | Answered on May 08, 2013


fuel filter locared on drivers side under carriage on frame, you probaly can't see it because it may have a shield or dirt. it is being held with a 3 to 5 inch worm clamp. WARNING!!! You will need to use a fuel line tool to disconnect lines. Failure to do say and attempting to remove without the tool can be costly.

1996 Ford Ranger... | Answered on Apr 29, 2013


If your oil pressure gauge is reading normal I wouldn't think so. You need to get your codes read with a scan tool and find out what the computer thinks the problem is.

1996 Ford Ranger... | Answered on Apr 23, 2013

Not finding what you are looking for?
1996 Ford Ranger SuperCab Logo

742 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ranger Ford

  • Ranger Ford

Most Popular Question

cause 1996 ford ranger no going in gear

  • Cars & Trucks
Loading...