20 Most Recent 1996 Ford Taurus - Page 3 Questions & Answers

what line? what are you referring to as a "junction box"? What is the problem with your brakes? I’m happy to assist further over the phone at https://www.6ya.com/expert/josh_8f8ad0a8f7e0e6d3

if you want to do it yourself , get a workshop manual from a local parts store and read up on bearing replacement then you will know what tools are needed and the procedure before you start it is too involved to explain it all here .

Check bateries cable at first then check if current goes to the starter

The best way is to use the vehicle VIN number, here is a link to a Ford Vin Number Look-up site, that will tell you the transmission code and the type of transmission you have:
https://www.fleet.ford.com/maintenance/vin_tools/default.asp

Sounds like your heater bypass valve stopped switching. Does your engine get up to operating temperature? Or does your engine not have a temerature gauge? If you do not have a gauge it could be one of 2 problems a stuck open thermostat or the heater bypass valve.

sounds like over drive switch or transmision box

Fixing Ford Taurus Shift Problem. Replacing VSS Vehicle ...

? 7:17 www.youtube.com/watch?v=y0823ZDqxiU Aug 12, 2010 - Uploaded by Larry W Changing the VSS on a 99 Ford Taurus 3.0L Duratec 24Valve DOHC engine. Symptoms: ... Replacing VSS Vehicle Speed Sensor. Larry W.

98 ford Taurus VSS (vehicle speed sensor) - YouTube

? 1:42 https://www.youtube.com/watch?v=OoPKhl2p6ao Mar 14, 2015 - Uploaded by Sharon Kay Location of VSS and how to get to it on a 98 Ford Taurus. Disregard the yr i give in the video. I have 2 other ...

Check your owners manual for location, position, and fuse size...did it just stop working?

it is your intake air control

that is the time the mechanic is alotted to do the job if it takes him longer than they dont get paid for their extra time

Not sure what 'spitting' means, but I'd suppose an exhaust leak may sound like a spitting noise...

Usually mounted near the EGR valve. Just follow the hose from the EGR tube.

well its bound to make a little mess but you should have a drain plug on the radiator at the bottom towards the engine side on one of the 2 tanks (sides of radiator ) unscrew drain plug and let drain into a pail or pan ( 2 gallon ) after it drains remove lower radiator hose. use a garden hose and fill radiator and let it flush for a little, hook lower radiator hose back, tighten drain plug and fill with a 50/50 mix new antifreeze,

On a 3.0 v-6 it is located near thermostat (where upper radiator hose hooks to engine). This is for computer.

There are two fuses for the blower. One for the relay coil and the other for the relay power. One is a 5a in the interior fuse box. The other is a 40a in the engine compartment fuse box.

Most likely you have a linkage problem between the shift lever and the transmission and or the rubber bushings for that linkage are bad. It can also be the pivot point of the shift lever.

Owner's manual? troubleshooting. Diagram on lid of fuse box. No Owner's manual? try this: Good resource for other problems in the future. http://www.taurusclub.com/forum/82-maintenance-repair/140892-need-fuse-box-diagrams-info.html Or manualslib.com

What was it doing before? What changed? Who did the work? "tripple check" Probably bad connection in the electrics.

If we are talking of the high mount brake lamp the bulbs are accessed from the top of the rear deck. Remove the housing by pulling it firmly and there is access to the bulbs