20 Most Recent
1999 Ford Ranger SuperCab - Page 11 Questions & Answers
Ac not cold 95 ranger
check for freon leak, check belt on compressor. garage can put a yellow dye in system to show smallest leak.
What is the MAP sensor?
it reads air speed and temp and sends signal to computer telling it how to mix the fuel and air
Overdrive will not disengage
HelloThe engine
and transmission in this cars drive train are fully
electronically controlled by a computer called the PCM (Power Train
Control Module). Whenever a problem like this occurs the computer
stores a record of the problem (there are of course some exceptions
to this, like the fuel pump for instance) in the form of a fault code
in its memory, to read these fault codes you must have the systems
memory scanned with a special tool. Once the fault code(s) are read
you then must perform the appropriate diagnostic testing to find and
resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL THE
DIAGNOSIS & TESTING IS COMPLETED.
Compressor kicks on but no air
sounds more like a temp door is stuck feel the larger pipe for the ac while it is running if its cold you have a door problem
1999 ford ranger 3.0 spark plug wiring diagram
More important than the length is the routing of the wires to reduce chances of cross-feeding of the ignition pulse into another wire.Don't know if any place shows the routing of the plug wires.. You may need to look at another engine like yours to see how the wires are routed and which length wire goes where. Good luck.
Not finding what you are looking for?