20 Most Recent 2004 Ford Ranger - Page 6 Questions & Answers


had the same problem with my 2003 expedition replaced the coil packs and now it purrs like a kitten

2004 Ford Ranger | Answered on Apr 07, 2014


You must have a wiring diagram to put them on correctly.

2004 Ford Ranger | Answered on Mar 31, 2014


Ford has a TON of technical service bullpens for this code but mostly on F-150s. Call your local dealer and ask for the service manager. If he is an honest fellow, he may let you in on a secret recall. Otherwise, The code is for crankshaft position/camshaft position input signal error.

Good luck.

2004 Ford Ranger | Answered on Mar 25, 2014


well you change it the readings on the meter are a bit incorrect

2004 Ford Ranger | Answered on Mar 20, 2014


it may be the starter that could be not working or there may be problem with the key tough in some cases that can be it if the key is not apropiate for the car

2004 Ford Ranger | Answered on Mar 20, 2014


ecm probably faulty

2004 Ford Ranger | Answered on Mar 20, 2014


Can be several things with the sensor, ground wire, or PCM. The wiring and sensor are suppose to have a predetermined resistance and 5 volts of power. The PCM monitors temperature and if the engine runs and the temperature is not above 32 degrees a fault is Coded when the wire resistance does not match. In your case it's too high.

You might try to clean the connector or see what voltage is available to your PCM and the sensor. The sensor is by far the cheaper thing to guess at. You are probably getting enough juice to toggle the electric cooling fans but not appropriate voltage to satisfy the PCM.

2004 Ford Ranger | Answered on Mar 17, 2014


Some noise is common, but excess play in the C-V shaft in the front drive units can caused excess noise. This is kind of a judgement thing; someone should put the truck on a lift and physically inspect the front components.

2004 Ford Ranger | Answered on Feb 01, 2014


This is a code for the fuelcap and Emissions fuel venting system. Perhaps a line was in the way of the oil fill and you jarred it loose. Your gas cap may also not be sealing.

2004 Ford Ranger | Answered on Feb 01, 2014


in the driver door jamb near the striker there should be a sticker with calibration code it should look like this.
11111ae4-5307-475d-a9fc-14288368205c.jpg

2004 Ford Ranger | Answered on Jan 26, 2014

Not finding what you are looking for?
2004 Ford Ranger Logo

762 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ranger Ford

  • Ranger Ford

Most Popular Question

fuses checked 2004 ford ranger not

  • Cars & Trucks
Loading...