20 Most Recent 2001 Dodge Intrepid Questions & Answers


Electric Engine Fan - Fan Switch

Removal & Installation
2.7L Engine
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. Disconnect the electrical connector .
  4. Remove engine coolant sensor from coolant outlet tube .
To install:
  1. Apply thread sealant to sensor threads.
  2. Install engine coolant temperature sensor into coolant outlet tube.
  3. Tighten sensor to 20 ft. lbs.(28 Nm) torque.
  4. Connect electrical connector to engine coolant temperature sensor .

3.2L And 3.5L Engines
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. With the engine cold, disconnect coolant sensor electrical connector.
  4. Remove sensor.
To install:
  1. Install engine coolant temperature sensor.
  2. Tighten sensor to 20 ft. lbs.(28 Nm) torque.
  3. Attach electrical connector to sensor.
  4. Connect negative battery cable.
Removal & Installation
  1. Disconnect negative battery cable.
  2. Partially drain cooling system.
  3. Remove upper radiator hose.
  4. Disconnect cooling fan electrical connector.
  5. Remove cooling fan mounting bolts.
  6. Remove radiator cooling fan assembly from vehicle.

    f9d971c.jpg
    Fig. Removal and installation of the radiator fan-2.7L Engine shown
To install:
  1. Position radiator cooling fan assembly in vehicle.
  2. Install cooling fan mounting bolts. Tighten to 50 inch lbs. (6 Nm)
  3. Connect cooling fan electrical connector.
  4. Install upper radiator hose .
  5. Fill cooling system.
  6. Operate engine until it reaches normal operating temperature.
  7. Check cooling system and automatic transmission for correct fluid levels.

Hope helps (remember comment and rated this).

2001 Dodge... | Answered on Dec 11, 2018


ya that happens everytime enjoy there not bearings but check ball for pressure ...your answer is torx scews

2001 Dodge... | Answered on Feb 03, 2018


Look on passenger side at back of engine/transmission housing area.
12_12_2011_1_56_03_am.gif

2001 Dodge... | Answered on Nov 30, 2017


the concept of that cable is it controls trans line pressure. watch a you tube vid of how to adjust it and do it before you smoke your transmission

2001 Dodge... | Answered on Oct 29, 2017


Hydraulic lifter has failed. Replace the lifter before it wears out the camshaft lobe.

2001 Dodge... | Answered on Aug 26, 2017


Only thing I can is do you have a check engine light. If you do what is the code. Many auto parts stores will read your code for free.
What you said picks up slowly and tops out at 35 mph. My Chrysler 200 took 2 block to get to 2000 rpm 30 mph. That was all it would do. I had a code and changed the throttle body sending unit. The throttle body and sending unit are 1 piece unit on my car. some cars you can change just the sending unit. It improved 75 percent and when we changed gas station 3 weeks later the problem went away. With the limited info you gave that is all I got. Hope it helps.

2001 Dodge... | Answered on Aug 08, 2017


It's a cable that runs from the pedal to the throttle body

2001 Dodge... | Answered on Oct 13, 2016


You also have to remove everything in the front of the engine. Valve cover is just the first thing to come off. You need a manual.

2001 Dodge... | Answered on Jul 05, 2016


Check the ASD relay , auto shut down relay in the under hood fuse / relay box . The ASD relay supplies B+ voltage to the injectors an ignition coils plus other thing's ! This may be you device voltage code problem as well as the other codes

2001 Dodge... | Answered on May 11, 2016


What engine do you have, there are two in this year.

2001 Dodge... | Answered on May 06, 2016


Duplicate question.

2001 Dodge... | Answered on May 06, 2016


Many many reasons, camshaft drive chain failure (2.7 V6) is one, no spark is another, no fuel pressure is another, if not cranking over with the starter then the battery can be the cause or the cables to it are loose or corroded.

2001 Dodge... | Answered on May 06, 2016


You need to go under the car and inspect for damage, I think this musty have been more than just a bump.

2001 Dodge... | Answered on May 06, 2016

Not finding what you are looking for?
2001 Dodge Intrepid Logo

925 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Intrepid Dodge

  • Intrepid Dodge

Most Popular Question

replacement egr valve

  • Cars & Trucks
Loading...