Top 20
2005 Dodge Neon - Page 3 Questions & Answers
Where is fuel filter located
The fuel filter on a Dodge neon is under the right rear.
https://s.yimg.com/fz/api/res/1.2/h.pb_Hwv_LwohlQ3qWF5VA--/YXBwaWQ9c3JjaGRkO2g9MzU2O3E9OTU7dz01MzU-/http://0.tqn.com/w/experts/Chrysler-Repair-807/2008/10/3-hoses-fuel.jpg
Car overheating
So it was about half empty and they said it was OK. Keep check on the coolant. Look for leaks.
Exhaust leak in 2005 dodge neon seams to be in front how can i find it and fix it
Since you wired up the muffler most likely the break is around the muffler. Easiest way to find it is to put it in park, have a helper rev the engine to say 1500-2000rpm, then from under the car move your hand around different areas and you'll feel the exhaust coming out where the leak is. Just make sure you don't touch the exhaust or you'll get burned, just place your hand near the pipes not on them!
Is the horn on a 2005 dodge neon connected to the air bag
no they are 2 separate systems even though the air bag is in the horn pad the contacts for the horn are separate from the air bad itself. if you have to replace the horn pad because of a problem you will have to disconnect the air bad circuit by unplugging the yellow plug connector under the dash by the steering colume and let sit for 20 minutes for the back up power to de-energize. most horn problems are the horn itself.
2005 Dodge Neon wont start.
First check the Timing belt next cam sensor CPS then the throttle position sensor TPS they work together so to tell if all of the internal parts are in line. That way they will not bang togather.
Wont start
Ok then so what is you question.????????
Delayed start on dodge neon
Make sure tranny is in park or neutral and the parking brake is set. Use jumper wire at the starter relay, terminals 25 and 26 in diagram, the starter should crank normally, does it? If so, the problem is on control side of relay. Can't tell from here if ignition switch--or pcm? The pcm is ground for control side of relay. It could also be wiring circuit or connector?
When testing make sure tranny is out of gear and vehicle can't move. Safety is your responsibility.
Not finding what you are looking for?