20 Most Recent 2004 Dodge Ram Questions & Answers


fuel regulators are normally found on the fuel manifold and have a line going back to the tank of the inlet side of the pump

2004 Dodge Ram | Answered on Apr 26, 2019


It is really a simple set up that makes a car run. The components involved are as follows,
Computer, temperature sending unit, oxygen sensors, throttle position sensor, fuel pump and a few others that help complete the process. The fuel pump keeps the fuel pressure to 44-55 psi . The injectors are in the closed position and can only be opened with an electrical pulse. The pulse is sent to the injector by the computer. The length of the pulse is determined by the information given it by the temperature sending switch and the throttle position sensor. The computer see how hot the engine is and how much throttle the driver wants. Then it sends the current to the injector, pulse time, that opens the injectors for milla seconds. The oxygen sensor measures the amount of air in the exhaust and sends that result to the computer which analyzes all the information and makes changes to the pulse time and makes the changes to have a fuel mixture of 14.7 to 1 ratio of air to fuel. This happens about 20 times a second depending on your speed.

2004 Dodge Ram | Answered on Feb 19, 2019


get codes read again . electronics do fail quite often

2004 Dodge Ram | Answered on Nov 18, 2017


That's an indication of a stuck thermostat, not letting coolant circulate.

2004 Dodge Ram | Answered on Sep 21, 2017


most likely the idle air control valve is dirty or needs to be replaced.

2004 Dodge Ram | Answered on Sep 09, 2017


It maybe as simple as a bad radiator cap ! If not refer to You Tube !

2004 Dodge Ram | Answered on Nov 05, 2016


No, not at Fixya.

Do checks though. Beware of title washing with a vehicle like that one (trading through an intermediate buyer to sell a damaged vehicle) Get a history report like CarFax, it is worth it.

http://www.nclnet.org/avoiding_online_car_buying_scams

http://www.autobytel.com/car-buying-tips/car-buying-*****-tips/top-10-car-scams-while-buying-or-selling-100460/
.

2004 Dodge Ram | Answered on Nov 04, 2016


Click on Clyde's response in blue .

2004 Dodge Ram | Answered on Nov 26, 2015


Check your wiring. I know that these trucks have that problem mainly with the passenger side but I'm sure it could happen to the driver side as well. See what happens is they run the wiring through the door near the hinges and when you open/shut your door it wears the wiring causing it to short. My passenger side doesn't work with the passenger controls but will work on the master controls. I will be fixing mine here shortly.

2004 Dodge Ram | Answered on May 04, 2015


Possible Causes:
Transmission Control Relay harness is open or shorted
- Transmission Control Relay circuit poor electrical connection
- Faulty Transmission Control Relay
- Faulty Transmission Solenoid/Pressure Switch Assembly

Read more: http://engine-codes.com/p0888_dodge.html#ixzz3Z8ifNjHs

I hope this helps! :)

2004 Dodge Ram | Answered on May 04, 2015


The computer is not happy with the motor change. There is probably a security code system that needs to be reset. It may be as simple as the radio security code which dealer may have by vin number. But more likely the internal computer needs a reset, most likely also by dealer.

2004 Dodge Ram | Answered on Apr 01, 2015


Try the following link. Only one tool is required. If the old one is not broken, pay attention as to how is routed before removing.
04 Dodge Ram 1500 Serpentine Belt Replacement 2004 Dodge Ram 1500...

2004 Dodge Ram | Answered on Mar 12, 2015


Open up the tail gate, you will see two torque screws on the inside beside the tail lights. take these out, this will free up the housing and you can change it from there.

2004 Dodge Ram | Answered on Dec 09, 2014


That doesn't sound fun. What is the question?

I’m happy to assist further over the phone at https://www.6ya.com/expert/josh_8f8ad0a8f7e0e6d3

2004 Dodge Ram | Answered on Jun 06, 2014


If the clutch cycles on for a moment, then stops, and repeats, it's low on Freon. If it never even tries to spin the fuse my be blown.

2004 Dodge Ram | Answered on May 19, 2014


We do not have the diagrams you need, they are copyrighted. Sorry.

2004 Dodge Ram | Answered on Apr 17, 2014


I know I had the same problem with my 2004 3500 Cummins...try turning the key to the crank position and let it go (this will allow the fuel pump to run for about 25 seconds, basically priming the pump). Try starting the truck again, if it cranks over and sounds rough this is normal. Let it run until it goes back to normal. If you cannot crank the truck over keep repeating the process above (making sure you turn the key to the off position after each time you try). **This information I found out of my Chilton Dodge Repair Manual**

2004 Dodge Ram | Answered on Feb 21, 2014


check that the connection to the computer is pressed full home and is making good contact. Run fault codes to find any faulty sensors. Reset the CPU using a code reader.

2004 Dodge Ram | Answered on Jan 08, 2014

Not finding what you are looking for?
2004 Dodge Ram Logo

248 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Dodge Ram
1999 Dodge Ram

1,750 Questions

1994 Dodge Ram
1994 Dodge Ram

192 Questions

1998 Dodge Ram
1998 Dodge Ram

139 Questions

1990 Dodge Ram
1990 Dodge Ram

113 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ram Dodge

  • Ram Dodge

Most Popular Question

need wireing diagram o2 sensor 2004

  • Cars & Trucks
Loading...