20 Most Recent
2006 Dodge Ram - Page 9 Questions & Answers
I have a 2005ram srt10,when I put a ohm meter on the negative terminal and the hot lead on the meter to the fender I am reading voltage.
You should disconnect the battery first as you appear to have a short. Look for a broken or damages wiring harness around the fender. Where does the ground originate that you had taken "loose"? Did you fix anything recently or hit anything? Did you check that the red (positive) cable is attached to the positive (+) terminal on the battery? How much voltage were you seeing at the fender? did you test with a test light (tests the voltage potential under load)? Is your ground cable from the battery to the chassis and to the engine in good condition with tight fitting bolts?
My 1990 dodge ram van,318 ci eng.starts only when cold.Starter turns o.k.Runs well whe hot.Paul.
My first car was a 1969 Dodge Coronet station wagon with the 318 cubic inch engine. Loved it!
In my experience, the most common reason for this behavior is a bad crank or cam position sensor (assuming your car has one of those), since they tend to fail hot.
Another possibility is that a dirty or worn ignition switch is supplying power to starter, but not the engine, when it gets warm. Try spraying with WD-40 to see if that helps.
1996 1500 dodge ram v8 magnum won't start. I have
If it cranks good but won't start, make sure battery has a full charge. Have a helper crank it while you check for spark at the plugs, gasoline engine. If spark everywhere, use a gage and check proper fuel pressure and fuel injector pulse. Let us know what you find? I can only help with testing. You have to do the testing.
P1414 dodeg ram2012
Cylinder 4 reactivation controlled performance low oil pressure blocked oil passage m.d.s. solenoid open or shorted harness poor solonoid connection faulty engine controlled module
Not finding what you are looking for?