20 Most Recent
2001 Acura MDX - Page 9 Questions & Answers
Changing cabin airfilter for a 2001 acura mdx
It is. I believe on your MDX you have to remove the glovebox 10mm screws. Then there is a drawer in the plastic HVAC housing that unclips on both sides and slides out. If it hasn't been changed before, on most Honda and Acura SUVs you have to carefully cut the plastic that covers the support to remove the metal bar to get to the drawer. You need to keep the plastic because it screw into it's old position after the job is complete.
Mdx rear air fan not
maybe the fan itself is the problem, it could be a carbon brush problem,,,try to tp the motor while it is on, if it runs, then the brushes are short already...
i hope i was able to help
tnx,
drcool
pls rate me
RADIO RESET CODE
Go to any Acura dealer along with proof of ownership of the vehicle. They can retrieve the code from Acura's service network.
2002 MDX backup lights stay on
The back up lights are turned on by the transmission range selector switch, this is the switch that moves with the gear selection arm at the transmission, unplug the switch (large multi wire connector) and if the backup lights go out the switch has shorted and needs to be replaced, one question why don't you just remove the backup light bulbs until U install the new part??
MDX won't start on hot days
A faulty air conditioning system can cause overheating.
Fix: you may want to consider getting these parts of the vehicle checked:
Radiator
Air conditioning system
I hope this helps!
Discharge car freon
Are you saying that the freon is leaking. Most likely the seal in the compressor is the problem
2008 Acura mDx battery dies often
It seems that the battery is not the problem. It might be that you have a short our something that is draining the battery while the car is off. Have you had any accessories added to the car that require battery power? Anything plugged in etc.?
My back up camera stopped working on my 2004 MDX accurate
This happened with my '04 MDX. What I found was a broken wire. It was not at the camera but up in the wiring harness in the pillar/roof support. There is some slack in the wiring and you can pull it out a ways. I have no idea how or why the wire became damaged. Once repaired everything work fine.
Not finding what you are looking for?