20 Most Recent 2001 Chrysler 300M Questions & Answers


as long as the connector plugs match up you should have no problems.

2001 Chrysler... | Answered on Mar 06, 2019


Sounds like a faulty sensor, if the actual temp is 195/215. The ICM is processing the information it receives from the sensor and performs accordingly. A complete diagnostic scan would be helpful in determining the proper repairs needed to correct the problem.
Good luck...i hope this helps, please rate me a fixya.

2001 Chrysler... | Answered on Feb 11, 2019


www.reliable-store.com has books on every vehicle and also how to service/repair it.

service/repair/owner's/maintenance manual with
parts info, fuse box, gear box, PCV, torque specs,coiling, wiring diagrams, electrical diagrams, fuse diagrams, error codes, etc everything

Worth it

2001 Chrysler... | Answered on Mar 15, 2018


I suggest you get one of those manuals people get nowadays to do it yourself..
My nephew use it to repair my car and it's totally repaired now. Here's the website he bought it from.
www.reliable-store.com

2001 Chrysler... | Answered on Mar 06, 2018


is it intrepid?
I also have 2008 Chrysler Pacifica and I had purchased its manual from online store reliable-store.com. Here's the site link
I am sure they will help you

chrysler 300m 2001

2001 Chrysler... | Answered on Dec 18, 2017


most modern tanks have such a device in the filler tube for obvious reasons
take the hose off the outlet side of the fuel pump
connect a long hose from there to a container/s and turn on the ignition
if the tank is full you will need at least 3 X 20 litre gerry cans to hold the fuel

2001 Chrysler... | Answered on Nov 28, 2017


You can oh it, measure the ohms with a resistance or oh meter. Typical, at 70* F, the resistance would be 1000 ohms, use your model service data.
The sensor may have two sensors in it. One for the temp Gage, the other for the computer.
An other kind of sensor is a basic on or off, open or closed contact. This is used on dummy lights and to turn on the radiator cooling fan.

2001 Chrysler... | Answered on Oct 08, 2017


Most Chrysler computer are in the engine compartment

2001 Chrysler... | Answered on Sep 21, 2017


2 blocks is fast to reach boiling.Take the cap off the overflow tank and fill it right to the very top with coolant.Start the car and watch for a steady stream of bubbles.If you see a steady stream you do need a head gasket or have a crack somewhere in a combustion camber.

2001 Chrysler... | Answered on Jul 03, 2017


if a wheel bearing is going out then the abs could be sensing that. they are located in the same area. and or are the same. some ABS and wheel bearings are made to be as one unit.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tom_db3a51ff0ca57f20

2001 Chrysler... | Answered on Apr 22, 2017


Our all of the coils new or our they originals ? Our they in the same cluster or separated ? If they our all in the same cluster you will have to change the whole cluster. If they our they our signal's change the bad one. If they our new take them back to the parts house.

2001 Chrysler... | Answered on Mar 25, 2017


All the parts you listed are internal to the transmission. The cable is external - it runs from the shifter lever to the range selector lever on the transmission. Their analysis doesn't sound right though. If the cable is broken, the shifter should move freely as you described. But that (broken cable and bent lever) happened AFTER the problem of the transmission being stuck in reverse. Your efforts to unstick probably bent the shifter and broke the cable. It would seem something was jammed before you tried to get out of reverse, possibly inside the transmission.

2001 Chrysler... | Answered on Mar 09, 2017


Be sure it's not just a bad connection or wire that has departed the sensor itself.

2001 Chrysler... | Answered on Dec 06, 2016


II sounds like the battery lead is connected up incorrectly and it may not be allowing the battery to charge properly or maybe in reverse.
At some point your really need to cut your losses and take your car to an Auto Electrical professional who can visually diagnose the problem - quickly and cheaply.
You will get it fixed properly, and save a lot of heartache !!!!

2001 Chrysler... | Answered on Jun 09, 2016


My 2003 chryseler 300m can not see the light to the temperture counsel everything work just can see the temp

2001 Chrysler... | Answered on Apr 21, 2016


If it is not in the fuse box under the dash, by the driver's legs, then it may be in the box by the battery under the hood. The fuse boxes should have legends on them, but if they don't and you don't want to start randomly removing fuses, you can buy a fuse (continuity) tester at the car parts store relatively inexspensively. This tool allows you to test fuses without removing them.

Hope this helps,
matt

2001 Chrysler... | Answered on Apr 21, 2016

Not finding what you are looking for?
2001 Chrysler 300M Logo

530 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

300M Chrysler

  • 300M Chrysler

Most Popular Question

chrysler 300m replace positive battery

  • Cars & Trucks
Loading...