20 Most Recent 1997 Isuzu Rodeo - Page 8 Questions & Answers

i had the same issue and it was actually my gas cap. For some reason if the gas cap wasn't sealed all the way, i would get a strong gas smell inside the vehicle. try that 1st

your mass air sensor is about to go

The automatic transmission on the latest automobiles consist of a variety of components. These include: Planetary gear sets etc----------------------------------------------------------------------------------car key programmers

Put the bolts in until they all have the same length sticking out before tightening, that is how they go.

The thermostat should be in the housing where the upper radiator hose connects to the engine.

I don't see how that could happen, without being in an accidentOf coarse,as soon as the rack leaks, you replace itOn a frame mounted steering box just the bottom seal leaks& you have to remove & rebuildIf you have a damaged steering rack you have other possiblesuspension damageI would go to an alignment only shop,not some chain storein the mall

check the fuses first as two thing off at the same time usually a fuse probably the same fuse for both hope this helps

change plugs and wires

A mechanic would check for voltage at the blower motor, the resistor, the relay, and the fuse.

Hi there:DTC P0300 - Random/Multiple Cylinder Misfire DetectedThere are many issues that could cause this concern. Most common would be spark plugs and wires. A bad coil will also cause this issue. If this is the only code stored, it may be just that easy.Other causes could be the engine is running lean, such as a vacuum leak in the intake. Also low fuel pressure or a injector that is dirty or going bad. A clogged catalytic converter may also cause a mis-fire condition.

A code P0300 may mean that one or more of the following has happened:

• Faulty spark plugs or wires
• Faulty coil (pack)
• Faulty oxygen sensor(s)
• Faulty fuel injector(s)
• Burned exhaust valve
• Faulty catalytic converter(s)
• Stuck/blocked EGR valve / passages
• Faulty camshaft position sensor
• Defective computer

Additionally, I would check all vacuum lines it is very common on this vehicle for there to be a vacuum leak, if none are found I would get the fuel injection system cleaned it is often the cause of a misfire.Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day

go to the rockauto.com site and compare part numbers for each year and see if they are the same.

Check the alternator wires & make sure their tight & no clips are broken