20 Most Recent
2003 Jeep Liberty - Page 7 Questions & Answers
02 jeep liberty flooding
Check the fuel pressure ,high pressure will cause the injectors to leak. if pressure is within range suspect map sensor
12/4/2014 2:55:30 PM •
2003 Jeep...
•
Answered
on Dec 04, 2014
Speedometer not working
You are close but it is not the sensor in the rear end ,It is the speed sensor on the transmission
12/4/2014 2:11:13 PM •
2003 Jeep...
•
Answered
on Dec 04, 2014
How do I remove ear tail light 2003jeep liberty I removed 2 screws but couldn't get tail light out
quote, your oper guide. (missing"?)
what country? we can never guess that, and lighting laws, vary by.
drum roll, country. USA below....
- Before servicing the vehicle, refer to the Precautions Section.
NOTE
The rear lamp unit may contain up to four bulbs, depending upon the market for which the vehicle was manufactured. The service procedures for each bulb are the same, only the bulb sizes and types may differ.
- Disconnect and isolate the battery negative cable.
- Remove the rear lamp unit from the end of the quarter panel, as follows:
- Open the tailgate to access and remove the two screws that secure the rear lamp unit to the two plastic nuts in the side jamb of the tailgate opening.
- Pull the outboard side of the rear lamp unit rearward far enough to unsnap the two ball studs on the outboard side of the lamp housing from the two plastic grommets in the quarter panel.
- Disconnect the wire harness connector from the lamp socket plate connector.
- Remove the lamp from the quarter panel.
- Remove the two plastic grommets from the quarter panel and discard.
Firmly grasp the socket on the socket plate on the back of the rear lamp unit housing for the bulb that is being removed and rotate it counterclockwise about 30 degrees to unlock it.
10/8/2014 1:05:10 PM •
2003 Jeep...
•
Answered
on Oct 08, 2014
Not finding what you are looking for?