20 Most Recent
2004 Jeep Wrangler Questions & Answers
Where is the MAF sensor on a Jeep Wrangler 04
Locate the air filter box. From the box, there should be a large hose going toward the engine (air intake). There will be a few fasteners around the hose holding a smallish black box off to the side. The MAF sensor is inside that large hose, near that black box. It should be in the center of a plastic circular harness within the hose once you disassemble it. Be careful with the sensor, they are extremely sensitive to solvents. Use MAF sensor cleaner ONLY if you want to clean it (recommended for better MPG around every 20-50K miles). Hope that helps!
7/19/2023 8:25:46 PM •
2004 Jeep...
•
Answered
on Jul 19, 2023
I have a 4cyclinder 04
probably not clutch unless you are missing details
clutch problems will allow the engine rpm to increase with a road speed increase but that is not what you imply
if you did the brakes your self , then take it to an accredited brake shop for a proper diagnosis
10/28/2017 3:16:50 AM •
2004 Jeep...
•
Answered
on Oct 28, 2017
Heater blows cold air
the electric motor that open the heat door looses electrical connection there by the door stays on cold / it is located under the a/c heater assembly / which requires removing the whole dash and heater assy// also bleed all air out of coolant system
there are three doors / 1/ a/c heat 2/ mode /defors 3/ recurculation
[email protected]
9/14/2017 1:38:56 PM •
2004 Jeep...
•
Answered
on Sep 14, 2017
(2004 Jeep Wrangler) When the
need the clutch's and pressure plate replaced. clutch's are making the noise the pressure plate is making it vibrate. fix it soon.
8/27/2017 2:33:49 AM •
2004 Jeep...
•
Answered
on Aug 27, 2017
2004 Jeep wrangler 4.0 - 6cyl overheating
I had the same overheating problem in my jeep ! My problem was finaly found out to be the clutch in my fan its a different kind of clutch system it work as this. When your jeep gets warmer the tighter your fan clutch gets .While cool your fan moves slowly. now to test your clutch just warm up your jeep and rev it up a bit if your fan dose not pick up speed then it is sliping.What will come out of this is that you fan will the seez and run full all the time. if you jeep dose not overheat wile moving then it is not your thermo stat period.
5/13/2017 4:59:35 AM •
2004 Jeep...
•
Answered
on May 13, 2017
Location of fuel vapor leak detection pump 2004 jeep wrangler
try posting why you ask this firstmy guess, dash CEL glows, driving,guess 2, you get it scanned and it shows a DTC error you forgot to tell here, then assume its a bad part, named per above.why?first is to get the gas cap tight ( or new)and then push reset on the scan tool.then see if the undisclosed, DTC errors, goes away.this is first. all cars 1996 to NOW.unless building a EVAP leak down test system is fun. or easy.?? or guessing all parts in the system? why"see TJ jeep hereposted over 300 times, read the EVAP chapter.EVAP means in simple terms is GAS tank VENTING and Collection system. its a smog reduction system.2003 is free to read.
http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#servicechapter 25 "emissions"page 15 answers your question.
12/8/2016 1:54:48 PM •
2004 Jeep...
•
Answered
on Dec 08, 2016
Heater/Air air will blow
it sounds like you had the same problem I had a while back. There is a couple of "doors" on the blower motor that sometimes get stuck or broken, I took my jeep into an offroad shop and they fixed it with spare parts. They assured me that even if you took it to the dealer it's only like a 15-30$ part but it's the shop time that will kill you.
6/23/2016 11:51:20 AM •
2004 Jeep...
•
Answered
on Jun 23, 2016
WIRING DIAGRAM FOR FOG LIGHTS
stock?
TJ jeep that is what it is
and ive posted the answer here 100s of times now.
here goes again
front FOGS
chapter 8L covers this, (8 is wiring, L means lighting)
so ?
see TJ 2003 , same here.
see chapter LAMPS.
then wiring chapter.
schematic is 8W-50 fogs.
wiring + front, (index)
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service
its all there,
8W-50 (page 3,8,9 and 10)
if in usa, ignore EXPORT pages.... nobody here ever states there country , so..............................................mostly wrong answers.
10/22/2015 1:27:44 PM •
2004 Jeep...
•
Answered
on Oct 22, 2015
2004 jeep wrangler cluster does not work
stock car, no hacks?fuses to cluster, there are 2 fuses.the cluster has a simple self test mode, try that yet?first?2004 TJ, the book is freeread chapter 8J for self test (IIRC push trip button key on)if that fails 100% the fuses are blown.the word is "Actuator test" in that chapter.now the schematic, in chapter 8w, called wiringpage 40fuse 26 PDCand fuse 10 cab JB.the cluster is really a computer.Display system)when you jack the scan tool in, some power may leak form scan too to the display.forget the scan tool, for now,do the self test. first. if that fails, its lost power.http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#serviceposted over 100 times, now.
9/17/2015 1:22:45 PM •
2004 Jeep...
•
Answered
on Sep 17, 2015
How do i bleed air from coolant system
Take radiator cap off before you start the vehicle when its cooled off of course then leave cap off watch temp gauge till it reaches normal running temp the fluid should have dropped down in the radiator add coolant itll full you may have to keep adding depending on how much air is in the system put cap back on and turn vehicle off that is how you bleed a cooling system.
3/3/2015 9:40:48 PM •
2004 Jeep...
•
Answered
on Mar 03, 2015
On a 2004 Jeep Wrangler 4.0 it take about 30 sec to start I put a fuel gauge and it takes a while for the fuel to reach 45 psi I have to cycle the key on n off about 4 times then it will start after i
is this a double post, i just posted a huge full answer
just a while ago, on gc.
for same pressure..
the pump check balls bad,or fuelpumpreg inside.
or the injectors leak
last poster too, said awhile, 1s, 1min, 1hr what is while>
spec. is 1/2 min leak down or longer.
so>? but keyon 4 times, is fail
unplug injectors, (elect) is pressure 49 +-5 psi? and holds.
now, bingo.
leak down fails now.
yes the filers are all in tank
yes, the injectors can leak
un connect fuel rail hose, to rail block it.
hold pressure now
yes, bad leaking injector
no,, pump assy bad. assembly, why takes bench tests.
1/22/2015 2:03:23 AM •
2004 Jeep...
•
Answered
on Jan 22, 2015
Not finding what you are looking for?