20 Most Recent
2004 Volvo XC70 - Page 5 Questions & Answers
Rear wiper works intermittedly, often needs a push
Check Relay connection pins,check for dirty fuse, connect a direct power supply from a 2 nd battery, to the correct Pos/Neg. wiper motor terminals. If the Motor is good, it will energise immediately, if not, you got your answer.
Best of Luck.
Regards, DT
What is the position sensor bulb light on dash
Its one of the park lights, usually the tail light is the one that goes out. There are two tail lights on each side, it usually the top one (lowest light in the upper part of the tail light assembly)
I have to replace the ballast for the HID
You need to remove the front bumper. Five push clips along the hood line, remove the headlight wipers (if equipped), one T25 screw in the front of each fender well, then two 12mm bolts under the headlights (1 each side). Then there are 4 10mm bolts holding the headlight in.
I want to erase the information that says tiem for
turn the key to position I, push and hold the trip odometer reset until it goes to zero, continue holding the reset and turn key to position II, continue holding reset for about ten seconds, the warning triangle will start to flash, when it does let go of the reset and your done.
SRS AIRBAG SERVICE 2004 XC-90 MODEL
Most common SRS fault in XC90's is the driver side SIPS bag (side air bag) located in the side of the seat. The wire runs close to the hinge for the backrest and after working back and forth can break or short.
How do you properly remove inside panel on driver
Look for hidden screws, around the edge of the door, inside the door pocket, under the pull close handle and 'in & around' the door handle lever.
Then with those successfully removed, the whole door card should slide either up, or in the door edge direction to remove.
Be careful not to be too heavy handed, as this will undoubtedly break plastic lugs/clips etc.
Then once you have removed the door card, familiarize yourself, with where & how it fits on to the door for reassembly.
I hope I've helped.
Good luck
Blower motor 2001 xc70
There is a feature called afterblow. It was active on a variety of years and could be activated by the dealer when/if the customer was experiencing a musty smell from the air conditioner. Typically it will come on for about 3-5 min about 20-40 min after the car was shut down while the a/c was run.
I get a reading saying
The Misfire in Cyl 4 can be caused by
- bad/poorly connected/broken plug wires
- truly bad piston seal or scored cylinder wall.
- clogged/malfunctioning injector.
Only a compression test will reveal the true problem in cylinder 4.
Check the wires first though.
The bank 1 sensor is the front o2 sensor.
Thanks for using FixYa!!
"SRS - AIRBAG SERVICE URGENT"...message
If you have SRS and "brake failure" it should be taken to a dealer. a shadetree mechanic will screw more up than he will fix in this case. trust me on this! you will pay a price, but will save you more $ and less headache in the longrun.
Passenger door glass not connected to lift track
It is actually a fairly simple fix.
Open the door, remove the cover panel to access the inside panels.
There are 2 plastic grommets that attach to a slide track and the electric motor. The windo ride on the slide track.
It cost approx $10 for each grommet (you may only need the one)
I did it in a few hours (including running to the local dealer for the part) sorry do not remember the part number but the dealer will know.
I can not reset RSR air bag service urgent message on XC70
if your car has NOT been in a accident the easy fix would is to find a used AIR-BAG SENSOR on a car that HAS-NOT been crased what happened when you did that is sent a code to sensor without dissconnecting battery and light came on I did same ting changing the seat get another air-bag sensor and before installing it dissconnect neg battery terminal tape irt up with duct tape and replce sensor and problem should be solved
No Manual
The "w" is for winter mode, mostly for icy and snow conditions. It stops the car from accelerating to hard. As a experiment, activate winter mode a put your foot flat to the floor from a stand still position. You'll soon know what it does.
Not finding what you are looking for?