20 Most Recent
2006 Audi A6 Questions & Answers
2006 Audi A6 station wagon.
Call out a mobile auto electrician. The fob is part of the any-theft and immobilizer system. It needs reprogramming to the ECM and anti theft module. The will also check the battery and boost it and get you up and running.
12/30/2022 1:49:38 AM •
2006 Audi A6
•
Answered
on Dec 30, 2022
2006 audi A6 remote start
The car is on the trailer its been wrecked up front and all the front clip has been disconnected. I am not sure whqt all they unplugged off the motor. I have no recolkection of the car or its previous life. We cqn put money in it if it is worth it. I know it is maticulous inside for sure! I want to fix it.. but I don't want it to be another hamster wheel, I need to have that knowledge of what to do what to try what not to what has been tried excetera
5/18/2021 6:23:53 PM •
2006 Audi A6
•
Answered
on May 18, 2021
How do you change front brake pads on an Audi A6
How to change front brake pads & rotors (brake disc) on 2006 Audi A6:
Atention!!!
Don't disconnect any brake line from caliper!
Don't disconnect any ABS sensor!
For change front brake pads you must raise vehicle, remove wheels, extract the retaining spring of the caliper, and remove the caliper as follow:
1. Do not disconnect the brake hose from the caliper, and do not allow the caliper to hang by the brake hose!
2. Remove top and bottom caps (on back side of the caliper) for access to guide pins, then unbolt and remove them from the brake carrier. Remove the caliper.
3. Now you must thoroughly clean the brake calipers (free of grease).
4. Remove outer brake pad from brake carrier.
5. Pull inner brake pad out of brake caliper piston.
6. Remove brake carrier from wheel bearing housing (two ribbed bolts). 125 Nm
7. Remove brake disc from wheel hub.
8. Install brake carrier on wheel bearing housing. Tightening torque for two ribbed bolts = 125 Nm.
9. Check up the brake fluid level on the reservor, and emptying if neccessary!
10. Push piston back into brake caliper housing.
11. Install inner brake pad (with expanding spring) in brake caliper piston. (Arrow marked on pad - if exist, must point in direction of brake disc rotation when vehicle is moving forward).
12. Install outer brake pad into brake carrier.
13. Bolt brake caliper housing to brake carrier using two guide pins. Tightening torque is 25 Nm.
14. Install both caps.
15. Insert retaining spring into brake caliper housing. Important: Depress the brake pedal firmly several times while the car is stationary so that the brake pads adjust to their normal operating positions!!! Check brake fluid level and top up if neccessary!!!
2/17/2019 2:08:20 PM •
2006 Audi A6
•
Answered
on Feb 17, 2019
Audi mmi navigation
If you're asking about navigation map update, here's a tutorial on how to do it:
7/4/2015 1:57:57 PM •
2006 Audi A6
•
Answered
on Jul 04, 2015
Not finding what you are looking for?