20 Most Recent 2004 Ferrari 360 Modena Questions & Answers

Try to isolate the problem. If the current flow is between the fuse block and the window switch you may be grounding somewhere between. Next check the window switch. If there is current flow across the switch when not being used, replace the switch. There should be no current at the window motor until the switch is engaged. On the other hand, you could just buy one of those solar powered battery chargers for about $40 to keep the battery up and not worry about it until something fails.

Obviously the computer in you car does not sense the airbag. It could be something simple like a bad connection or something major where the propellent or gas generator in the old airbag is faulty. In any event your system will not deploy so you should recheck your wiring and if that doesn't fix the problem, the airbag should be replaced.

Open the bonnet area, you will find the master switch on the upper left area, turn it OFF (right). After one minute, put the ignition in POS 2 without starting the car, leave for 30sec, start the car BUT leave idle for 10 minutes.

OBD Diagnostic Tool may be help you.

Its the voltage regulator,its screwed on the left side of the heater unit under the dash,i think with 3 screws and a plug.Its about 6 inchs long round on one end and flat on the other end.I had this problem with mine its quite common Nigel

it's not easy to that

Hold Down Clutch While Starting

Hello and welcome to Fixya!
As a first course of action, I strongly suggest that you remove the positive batter connector and let it sit for atleast 5mins. before reconnecting it. This will reset the system and can get your vehicle back to it's normal operation.

Please do keep me posted on the progress. I'll be glad to help you out. Hope this helps and thank you for using Fixya! Have a good one!

Time to open up the cluster and check for bulbs being out, or a shorted wire. Do the dials and gauges still work, and is there a dimmer on your model. I remember the older Ferrari's' having a dial type dimmer, you may have moved it to the lowest setting that would make them appear off.