20 Most Recent
2000 Isuzu Rodeo - Page 6 Questions & Answers
My slave cylinder on my 2000 Isuzu Rodeo went out and I need information on the procedure required to replace it ?
what you need to do is buy a replacement (new) cost is relvantly cheap. the correct brake fluid in aust it is known as dot 3 don\'t use any other even the multi dot 3/ 4 is no good for rubber seals. place a line lock on rubber part of hose so you don\'t loose the fluid from master cylinder . remove old unit by undoing the banjo bolt which carries the fluid first then the location bolts. replace new unit in reverse order bolted on then the fluid bango bolt with the washers to seal the fluid . after fully bolted back in undo the bleed nipple on the slave cyl then remove the line lock, keep the resvoir full with new clutch fluid . let the old fluid gravety feed out of complete unit , remembering to keep res full once new fluid is coming thru , tighten the bleed screw and get some one to help you bleed the unit properly . very easy job to do and quite common as the brake fluid is hydrascopic meaning it absorbs water , the water goes to the lowest point being the slave cyl. it is recommended that brake fluid and clutch fluid be replaced yearly due to the hydrascopic nature of it and it is the water that damages the seals and surfaces which then fail just as yours has . hope this helps mate
It idles but when put in gear it goes dead
spark plugs, a tune up is not 1 filters.read the 60k, service points list? bingo.sounds like you have no engine power. (not tranny slip)]if rpm goes high and you dont move, the tranny is slipping.causes?of low engine power are 50 , reasons.but top 2.never did the 60k. (tune up)]low fuel pressure for any reasons.tell engine size, lots of sizes, cant guess that or what to do next
How to change starter on 2000 Isuzu rodeo
like all cars. youtube it.
1: REMOVE battery neg lug.
2: remove the wire to starter solenoid.
3: remove the bolts, holding it to bell housing.
bam its out.
reverse above to put back.
How to bypass immoblizer and theft system on 2000 isuzi rodeo
Have you verified the timing belt isn't broken? It's getting fuel?
Have you recently purchased a new ignition key, or did the battery go dead on your fob? Could be fuel pump, or even a fuse.
Start the cheapest....Check all fuses, under the dash and the hood. Listen for the fuel pum to buzz when key is turned on.
1999 rodeo front axel is locked in gear
this is part time 4wd
drive to dirt and deselect 4wd,
do not engine PT 4wd on dry pavement or risk damage to drive line
RTM read the manual in the glov e box.
the do's and don'ts
Does the camshaft sensor have anything to do with the fuel injectors (1995 izuzu rodeo)
sure does.
the engine has 2 sensors,
cam and crank
together the 2 tell ECU where #1 fires and all cylinders fire.
and on new cars with sequential injection the injectors are fired 1 my one, timed from both.
why not post symptoms.
if you connect any scan tool made, it will tell you when either sensors is bad, if cranked for 5seconds. will
post symptoms and stop guessing.
Not finding what you are looking for?