20 Most Recent
2000 Mercury Villager Questions & Answers
Where is the fuel filter located on a 2000 Mercury villager
I'm assuming it's a fuel injected engine. If so, and you can't see an in-line filter after tracing the lines, it's probably in the fuel tank. If the fuel supply, return, and vent hoses go to the top of the tank, pull the carpeting or back seat, whichever is above the tank, and look for a screw down plate. When you remove the plate, it will give you access to the housing for those items.
Mercury villager problem
Don't take chances with brake issues. All anyone here can do is guess what the problem might be. Get it to a dealer or a reputable mechanic - have it towed if you're afraid to drive it - and have it diagnosed and repaired.
Windows do not go down or open on 2000 Villager
Check all fuses,If switches for other doors work, test and replace driver multi switch if defective. Switch OK, you will have to check wires for damage at hinge area of door by removing protective sleeve, if wires are damage, make repairs.
Car is not overheating but is stalling after id drive it for a short while?
HelloThe
Engine and Automatic Transmission (not applicable to manual
transmissions) in this vehicles drive train are fully
electronically controlled by a computer called the PCM and TCM (Power
Train Control Module, Transmission Control Module). When a problem
like this or other drive-ability related problems occurs the computer
stores a record of the problem (there are of course some exceptions
to this, like the fuel pump, engine coolant temperature sensor and
MAF sensor for instance) in the form of a fault code in its memory,
to read these fault codes you must have the systems memory scanned
with a special tool. Once the fault code(s) are read you then must
perform the appropriate diagnostic testing to find and resolve the
problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED
TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD
EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always
check fuel pressure for correct spec for your make and engine type.
Transmission slipping at low speeds
Have the filter inside the transmission changed. If that doesn't solve the problem then the clutch plates have worn too much or the front pump is not supplying the correct fluid pressures. That would need a complete rebuild to fix.
Not finding what you are looking for?