20 Most Recent
1999 Plymouth Voyager - Page 8 Questions & Answers
Leftturn light works rightturn will not flash
Make sure that you have at least one good bulb on the right hand side.If that is good then the problem normally lies in the indicator switch itself.This means removing the indicator lever and locating the switching contacts for the indicators.One of the contacts will probably be dirty or corroded.Clean the contacts and all should be ok. A bit of adjustment may also be needed.
Battery loses charge over night when parked
Make sure your fan belt is correctly tensioned .If so,remove one battery lead and with every thing switched off tap the battery lead on the battery teminal.If you see sparking this will indicate a voltage draw on the battery . My guess is that you probably need a new battery.Take it to a battery sales place and let them check it for you.
Brakes are hard to stop
if you push the brake pedal is it hard? do you have to "stand" on the pedal to slow the vehicle? If so, your pads/shoes need to be replaced and check the rotor(s) and or drum(s) for signs of "glazeing" (goldish or bluish color). if they are, they are you will need to have them turned or replaced.
I need to know where the oli sending unit is and
Fig. 1: Location of the oil pressure switch-3.3L and 3.8L engines
Fig. 2: Location of the oil pressure switch-3.0L engine
Fig.: Oil pressure switch (sending unit) schematic
The low oil pressure warning lamp will illuminate when the ignition switch is turned to the
ON
position without the engine running. The lamp also illuminates
if the engine oil pressure drops below a safe oil pressure level. To
test the system, perform the following:
-
Turn the ignition switch to the
ON
position.
-
If the lamp does not light, check for a broken or disconnected wire around the engine and oil pressure sending unit switch.
-
If the wire at the connector checks out OK, pull the connector
loose from the switch and, with a jumper wire, ground the connector to
the engine.
-
With the ignition switch turned to the
ON
position, check the warning lamp. If the lamp still fails
to light, check for a burned out lamp or disconnected socket in the
instrument cluster.
REMOVAL & INSTALLATION
On the
2.4L engine, the oil pressure switch is located on the side of the
engine block facing the firewall. On the 3.0L engine, the oil pressure
switch is located on the oil filter adapter housing, next to the starter
motor. On the 3.3L and 3.8L engines, the oil pressure switch is located
next to the oil filter.
-
Locate the oil pressure sending unit on the engine.
-
Disconnect the negative battery cable.
-
Disconnect the pressure switch electrical harness.
-
Using a pressure switch socket, deep-well socket or wrench, loosen and remove the pressure switch from the engine.
To install:
-
Install the pressure switch into the engine and tighten securely.
-
Attach the electrical connector to the switch.
-
Connect the negative battery cable.
-
Start the engine, allow it to reach operating temperature and check for leaks.
-
Check for proper oil pressure switch operation.
Hope this helps (remember to rate this answerr).
Oil light is dinging when idleing 99 plymouth voyager
The warning light is telling the engine oil pressure is below 10psi.The problem could be a faulty pressure switch, or the engine could really have low oil pressure.You can replace the switch, or check the pressure with a mechanical gauge and see what happens.
Speedometer won't work at all.
If the speedometer and odometer are both dead, the problem is usually the speed sensor in the transmission.If only the speedometer is dead, the speedometer and cluster may have to be repaired or replaced.
Not finding what you are looking for?