20 Most Recent
1998 Jeep Cherokee - Page 4 Questions & Answers
I have a jeep cherokee
Check the wiring harness between the "A" pillar and drivers door. The harness usually breaks there.
1/24/2015 9:22:17 PM •
1998 Jeep...
•
Answered
on Jan 24, 2015
Whats the approximate work hours involved in removing automatic transmission in a98 jeep cheroke 4.0 6cy 4x4
rust or no rust?
bent parts, or not : off road damage?
using engine out or not?
depend no shop equipment and skills
depends on luck (ah dang the bolt snapped off, and dang
the transfer case is stuck
or or or... i guess you;ve never done this, and experienced the realities, of all this.?
in my shop id jerk engine in 3hours.with trans.
on a pro lift with easy access, 8 hours end to end, no breaks.
(mine was a 5speed M/t new clutch ) but is same,
jack stands, xfr case off first, and the trans. to floor.
4wd takes a long time and some cars the exhaust is in the way
and then its rusted and must be cut off. and and and...
1/22/2015 11:44:34 PM •
1998 Jeep...
•
Answered
on Jan 22, 2015
What does code P0720 mean
Possible causes
- Faulty Speed Sensor
- Speed Sensor harness is open or shorted
- Speed Sensor circuit poor electrical connection
12/31/2014 5:43:58 PM •
1998 Jeep...
•
Answered
on Dec 31, 2014
Standard transmission
check for a clutch fluid level problem in the reservoir. IT sound like there is air getting into the clutch system and not giving you full clutch operation.
12/1/2014 9:08:51 PM •
1998 Jeep...
•
Answered
on Dec 01, 2014
How do I bypass the neutral safety switch on a 1998 jeep cherokee?
no transmission even stated, so can not answer. this.mine has 6 speed stick 2008, what do you have.?my guess is the car has automatic,and that it has a PRNDL switch on the side of said a/Tand that one segment is failing , NOT STATED WHICH.and you want to DO not want to fix it correctly and want to bypass it.bypassing the N/P is illegal. (car starting in gear is illegal in USA< but that "country" too, not stated)and bypassing the R, causes the reverse lamps to glow full timethat too is illegal. in all countries... and horror to other drivers.i must presume the engine wont crank, forget to stay that minor issue?my buddy has an old jeep, that is only used to pull STUMPS.it is never driven on the roadso i put a push button on the dash, with wire to IGN1, feedand the other to the starter solenoid (dinky wire)its UNSAFE AT ANY SPEED, LOL.you can too, but ill not say how, nor show pictures.
10/5/2014 12:47:07 PM •
1998 Jeep...
•
Answered
on Oct 05, 2014
Why does 1998 jeep Cherokee not run unless gas tank is at least half full?
2.5L or 4.0L? engine.
ever do a full service on this car , with a fuel filter.
or wrong gas cap, does car run ok cap off? or loose?
ignore cap off DTC errors. EVAP errors when done, ok?
start with basics.
then check fuel pressure, with a 1/4 tank, is it spec pressure with that brand new filter? yes/no.
the filter is part of the top of pump at top of the FP reg. in tank.
that be how its done. no need to guess. at all.
in this case, the pressure test is after, the cap checks.
the wrong cap will have a missing, cap vacuum breaker this cause
the pump to fail (it cant suck in a hard vacuum at all, get a new cap)
FSM spec, a the fuel rail for pump pressure,
Start the vehicle and note the pressure reading at idle which should be 31 psi (214 kPa).
if the car stalls with 31 PSI pressures , its NOT THE PUMP.
easy huh? just one tool and bam ,hard cold diagnostic facts.
evidence.
the tool can be had for $20
10/2/2014 12:57:04 PM •
1998 Jeep...
•
Answered
on Oct 02, 2014
Not finding what you are looking for?