20 Most Recent 1994 Chrysler LeBaron - Page 8 Questions & Answers

YOU CAN RUN 10W -30 OR 10W - 40 WEIGHT.IF YOU LIVE IN VERY COLD CLIMATES YOU CAN RUN 5W - 30.

could be a neutral or park switch

You might try changing the fuel filter, most likely the fuel pump is going out and will need to be replaced.

For 1994 Chrysler LeBaron Car Radio Stereo Wiring Diagram check...

Car Radio Battery Constant 12v+ Wire: Red
Car Radio Accessory Switched 12v+ Wire: Red/White
Car Radio Ground Wire: Black
Car Radio Illumination Wire: N/A
Car Stereo Dimmer Wire: Orange/White
Car Stereo Antenna Trigger: Yellow
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Green
Left Front Speaker Negative Wire (-): Green/Yellow
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Violet/Yellow
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Brown/Yellow
Right Rear Speaker Positive Wire (+): Blue/Red
Right Rear Speaker Negative Wire (-): Blue/White

Good luck (remember comment and rated this post).

You should check your light switch and see if it is broken. Hope this helps!?

Please rate solution - Thanks.

Click on the following free, direct Link. It has all the Timing Belt Diagrams with Marks you will need for your 1994 Chrysler LeBaron 3.0L.

Let me know if this helped or if you have additional information or questions. Feel Free to contact me at FixYa.com!

http://www.2carpros.com/car_repair_information/year/1994/make/chrysler/model/lebaron/1994_chrysler_lebaron_timing_belt_diagram_marks.htm

not user friendly do not do it your self get a pro to do it

replace the turn signal switch.

There should be a diagram attached to the car near where the belt goes showing how the belt is to run through the pulleys.
Newer vehicles have a tension pulley which is a pulley on a spring loaded arm that keeps the belt tight.

First run the belt on all the other pulleys and then use a wrench to hold the tension pulley back while you slip the belt on.

Older cars do not have a tension pulley and you had to usually loosen something like the alternator a little bit to get it on.

it is most likely in the switch it may have lost a ground or a broken wire

that your car runs really rich (more gas than it needs) then the excess comes out in a smoke from your exhaust. check to see if it spews out a lot of smoke next time you run it.

Without knowing what engine you have its hard to say, but included diagrams for all the engines...pick your set up and there ya go..




Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/sean_54c3a3dc48a7773c

THIS IS NOT OOD...NOT GOOD...YOU'LL NEED TO PUULL THE DIST TO SEE IF THE SHAFT IS NOT BROKEN AND THE GEAR IS STILL ON THE END....IF THE GEAR IS MISSING OR THE SHAFT IS BROKEN, YOU'LL NEED TO FIND OUT THE CAUSE... IF YOU CAN'T FISH OUT THE REMAINING PIECE OF SHAFT,, YOU SHOULD REMOVE THE ENGINE TO BE ABLE TO FULLY INSPECT AND REPAIR THE SHAFT...I THINK I'D OPT FOR A DIFFERENT ENGINE IF THE DIAGNOSIS IS BAD....THANKS FOR THE QUESTION

You have lost the accessory power feed due to high resistance at the ignition switch connector.
Most likely the switch will need to be replaced and if the harness plug is not heat damaged too bad you may be able to clean and crimped the terminals a little for better contact. In some cases you can buy just the connector end from the dealer as a repair part.

short in the wiring. More or less a positive wire is grounding on the body of the vehicle. you are going to have to trace it from the switch to the lights to see where the wire is broken, stripped , burnt or touching.

You were not specific about the color of the smoke or when and how long it occurred.

After a table top discussion this is the Best possible answer we can provide with information provided.

================================================


Engine Smoking from exhaust pipe, Possible but not limited to some of the below:
.
Black Engine running rich Possible Failure
-Map sensor, fuel injector or fuel pressure regulator.
Blue -Replace Faulty Transmission modulator valve
White Possible Failure. -Head gasket.
Hope this tip helps.
r/
David

You most likely have a bulb burned out

If you go to Auto Zone you can get the wire harness for a 1994 Lebron and all you have to do is match the colors of the wires, it take about 5 minutes to connect and tape, and ready to install after that. It will allow you to connect any radio, or cd to using the original wires.