1995 Chrysler LeBaron - Answered Questions & Fixed issues

0helpful
1answer

How do I remove the windshield wiper arm from a 1995 chrysler lebaron convertable?

To remove the wiper arm from a 91-94 LeBaron Convertible: 1: Remove the blade first. (Hood up was easier on mine) 2: From under the hood, lift arm high enough so you can get the small tab at the base of the arm to slide back toward the windshield about 1/4 inch. The tab won't move back until the arm is lifted enough to make clearance for the tab. With the tab moved back, it will keep the arm from coming back down if done correctly but BE CAREFUL that the blade doesn't spring down onto the windshield or put a towel down in the area to cushion any accidents! 3: With the tab now pushed back and holding the arm from returning down you can now slide (jiggle) the arm off from the shaft. It may seem still locked on but if the tab is out far enough to catch the arm from returing it is far enough and you just need to wiggle just right or maybe spray some WD-40 to help, but you really shouldn't need WD-40 Installation is reverse of these instructions.
6/4/2017 4:45:43 AM • 1995 Chrysler... • Answered on Jun 04, 2017 • 1,162 views
0helpful
1answer

Car will not stay running fuel keeps cutting out

Fuel filter, fuel filter. Usually in fuel rail under car on frame.When you ran out, you got debris in filter, when did you last change it?
5/15/2017 12:11:47 AM • 1995 Chrysler... • Answered on May 15, 2017 • 96 views
0helpful
1answer

My 95 3L Lebaron Dies when the car is stopped. It starts then dies immediately, after many cranks with lots a gas it will run. Only happens when cold.

I'd use a gage and check proper fuel pressure, key on engine off. My info says 48 psi. How long since over-all tune up?
4/16/2017 11:20:26 PM • 1995 Chrysler... • Answered on Apr 16, 2017 • 209 views
0helpful
3answers

Where is the starter located in a 1995 lebaron

starter is located on the drivers side near the radiator. the connections are a little difficult but the starter bolts are easy to get to and the starter is easy to replace. I replaced one in a parking garage. Took about 30 minutes
12/13/2016 5:26:41 AM • 1995 Chrysler... • Answered on Dec 13, 2016 • 469 views
0helpful
1answer

Where is the starter relay located?

no relay it is in the starter it has a relay in starter
1/31/2016 3:42:17 AM • 1995 Chrysler... • Answered on Jan 31, 2016 • 255 views
0helpful
1answer

My blower is not working and I don't know which fuse to check

Fuse #1 under the drivers side dash/side of dash controls the heater motor blower-not-working-dont-know-fuse-check-2weuas4jkbrvbhrwhonxf50x-3-0.gif
11/11/2015 5:50:13 PM • 1995 Chrysler... • Answered on Nov 11, 2015 • 135 views
0helpful
1answer

How to change a waterpump on a1995 chrysler le baron

Depends on the engine. If you have the 3.0 litre mits engine then you need to remove the timing belt as it is driven off the same belts. If I remember correctly the 2.5 litre four can be changed without removing the timing belt. Your best resource online for Chrysler is Allpar, a user supported Chrysler only site. Best info period. Allpar Dodge Chrysler Plymouth Jeep and related cars minivans and trucks
6/9/2015 3:48:12 AM • 1995 Chrysler... • Answered on Jun 09, 2015 • 339 views
0helpful
3answers

Serpentine belt chrysler grand voyager 3.3l 1997

Easy to do..... take your time! serpentine-belt-chrysler-grand-voyager-0egsa4g0vt3f5pkv1piq2dve-5-0.gif
6/8/2015 3:32:44 AM • 1995 Chrysler... • Answered on Jun 08, 2015 • 1,380 views
0helpful
1answer

Why is it not shifting???

Run the fault codes first check/change tranny oil and clean filter
4/12/2015 11:13:17 AM • 1995 Chrysler... • Answered on Apr 12, 2015 • 402 views
0helpful
1answer

My daughters 95 LeBaron with 80k miles on it doesn't get driven that often. All the sudden wont shift out of first gear. Had no problems yesterday or any other day. Any ideas?

Check the fluid level and color/appearance. If it is low, add transm. fluid. If the color is dark, or has a burnt smell or look, the transmission is probably done for. Look for a low mileage replacement. If the fluid is still clear and pink or red, and it wasn't low on fluid, have a transmission shop look at it. It may be repairable, at less cost than a replacement or a complete rebuild.
4/12/2015 2:36:09 AM • 1995 Chrysler... • Answered on Apr 12, 2015 • 61 views
0helpful
1answer

Why did both tail lamps and cluster lamps go out at the same time

You blew a fuse!
2/6/2015 1:19:01 AM • 1995 Chrysler... • Answered on Feb 06, 2015 • 26 views
0helpful
2answers

1995 chrysler Lebaron pasanger window is down, the motor runs but wont lift window

I had a caravan. Same symptoms. It had a plastic cable that would ease and lower the window. It stripped and wouldn't go up or down
2/4/2015 3:05:59 AM • 1995 Chrysler... • Answered on Feb 04, 2015 • 175 views
0helpful
2answers

Why does my heat gauge go up and down when I drive down the road

Change the gauge
11/7/2014 3:19:46 PM • 1995 Chrysler... • Answered on Nov 07, 2014 • 303 views
0helpful
1answer

Why does my heat gauge go up and down while I am driving down the road

Assuming the thermostat was properly installed, you are low on coolant (dont open cap if engine is hot) or your coolant temp sensor is bad.
10/24/2014 6:13:49 PM • 1995 Chrysler... • Answered on Oct 24, 2014 • 178 views
0helpful
3answers

How to troubleshoot

Its the fuse. The dashlights are on the same circuit so that you will know there is a problem
10/5/2014 8:00:12 AM • 1995 Chrysler... • Answered on Oct 05, 2014 • 189 views
0helpful
1answer

What is the fix for both tail lamps out at same time

It sounds like a fuse, shorted out wire or severed wire, but there are times where by coincidence both bulbs burn out at the same time.
10/3/2014 8:51:14 PM • 1995 Chrysler... • Answered on Oct 03, 2014 • 37 views
0helpful
1answer

How does a tension pulley work,got the pulley loose still cant get belt on,to tight.

Hi Bill, I'm glad to help. I've ran into this problem before. Here's what I deed, I went to the parts store and bought 2 larger sized belts and the one that did not work I took back to the parts store and got my money back. Hope this helps and have an awesome day Bill.
6/26/2014 10:28:45 AM • 1995 Chrysler... • Answered on Jun 26, 2014 • 57 views
0helpful
1answer

Where is crank shaft located

In the engine block, it usually has a pulley on the end
6/22/2014 9:36:12 PM • 1995 Chrysler... • Answered on Jun 22, 2014 • 29 views
0helpful
1answer

Chrysler lebaron 1995 engine schematic

Replace oxygen sensor
6/18/2014 9:16:43 AM • 1995 Chrysler... • Answered on Jun 18, 2014 • 117 views
0helpful
1answer

Want to know how to replace a belt for 1997 Chrysler LeBaron 3 liter V6

Chrysler did not make the lebaron in 1997, i need correct info to answer.
6/11/2014 7:19:46 PM • 1995 Chrysler... • Answered on Jun 11, 2014 • 166 views
Not finding what you are looking for?

313 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chrysler Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...