20 Most Recent
1996 Chrysler Town & Country - Page 7 Questions & Answers
Changing air filter 1996 chrysler town and country
loosen the clamp for the air snorkel at the throttle body. Loosen the clamp right under the reserve air chamber thats in between the radiator and the battery. Remove the breather hose from the air chamber. remove the two bolts holding the air chamber to the upper radiator support. remove the air chamber. there will be two retainers that need to be released on the transmission side of the air box and the the air box cover can be removed and the air filter changed I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_d728a59f986299fa
Air Con lights flashing!! Help!!!!!
- Start the van.
- Slide the temperature lever all the way to the left (full cold).
- Turn the Mode Control to ‘panel’ (the one that sends air to your face only).
- Turn the ‘blower switch’ to all the way to full.
- Now go to the leftmost three buttons. Press and hold the top one (rear wiper on constant) and the bottom one (rear wiper washer fluid) until the lights come on solid then begin to flash, and then you can let go.
- The AC will now calibrate. You will feel the air blow out of all the different zones at different intervals and see lights
come on and go off. Then after a minute or two the top button you
pressed will be slowly flashing. This means it has been completed.
- Press the last flashing button and you are done.
Why does my check engine light flash while driving
Can you read the flashes?Try reading the flashes a bit like morse code. something like flash..flash..flash...............flash...........would mean Error 31. Three consecutive flashes, a pause, then one more flash.If there are no pauses or anything though, then you will likely need an OBD computer to read the fault.
Broken water pump bolts
You need to take off trans mounts also either that or dissconnect trans, I'd go with the first option and either jack it up or use a cherry picker to raise it. I suppose you could lower with a jack or picker also if distance is less.
Noise from pulley
Buy a mechanics stethoscope and take a listen, they cost about $10.00
The gas gauge don't work
Hello and welcome to FixYa!
As a first course of action, please do check the fuse. If the fuse is blown, the fuel gauge won't work. If that's the case, please replace it.
If the fuse if good then the problem will be on the fuel float itself. The fuel float is located above the fuel tank. You will need to pull down the fuel tank to gain access to the fuel float. Once replaced, the fuel gauge will work normally again.
Hope this helps and thank you for using FixYa! Have a good one!
Not finding what you are looking for?