20 Most Recent 2006 Chrysler Sebring - Page 5 Questions & Answers

That code is for a knock sensor. You said you replace the camshaft sensor.

-If you already know it's the fuse then replace it and try to see what it will do. Good luck Mai

If everything was working before the battery change, whoever did the work broke something, disconnected something or did something else to cause the problem. Goo back to whoever changed the battery.

check the fuse box .if ok remove the lighter body .as outer cover inside may need to be tightened.

at the left side of engine

There are 2 8mm screws on top of assembly. Remove and pull out assembly. Disconnect wiring and screw out bulb. The screws are pretty long, so just keep screwing. It's really very easy.

this could be a injector problem or a coil failing-I would start with the coil pack and then the injector-you might try some injector cleaner in the fuel tank-Denny

remove the sockets for the lighters and on the back their is a small link from the + supply to the centre terminal and if you have used a pump or a water heater for coffee then the link burns out ,solder a bridge across and all will be well

General practice:Better use a lantern and a hook to pull the wires.If not,usually,under the clima controls knobs (pull out by little force),must have screws /clips to take out.If clima control is separeted by main,still may gain acces to wiring.The panel (s) needs side help to pop,do not use sharp/hard tools,plastic soft are better to avoid scratches.Many cars need to take the radio out also,this have side locking (ceck the small holes on sides,need a unlocking long thin tool)or by using a flat tool to unlock the pins by sides.Sometimes the panel (s) have taped (hidden) screw easily identyfing by close visual inspection.If the lighter has it's own painel u may need to pop this one out (like opening a phone).Inspect carefully and gently pull the sides with a plastic tool till figure out the removing sequence.U may put your finger in the hole to help it pup.U also may need to figure out how the lighter became loose.Watch for the corect wiring plugs.All advices are for general good practice,not for a specific car.Cheers.

Go to back of car grab tire and pull back and listen for a scraping sound it could be a mount up under the tire that has or is about to let go. lay down and look up and see if rubber is actually burning.