20 Most Recent
2006 Chrysler Sebring - Page 9 Questions & Answers
Heater will blow cold air randomly
Are the hoses going to the heater core hot. you can findv the 2 hoses under the hood ,and back of the motor. you may also have a sticking blend door
Where is the fuel filter on a 2003 chrysler sebring located?
Get underneath the vehicle. You will find the fuel filter on the trunk
end of the fuel tank, up towards where the top of the fuel tank meets
the bottom of the vehicle body. The bottom is flat and
smooth and it is the largest thing underneath your vehicle. The fuel
filter is a gray metal canister about the size of a small can of soup,
but a little bit fatter. It will have a rubber tube coming out of each
end.
How do I get to the drivers side light bulb in a
I will assume you are talking about the headlight?!
Removal
CAUTION: do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced life will result.
1) Disconnect and isolate negative battery cable.
2) Remove headlamp unit retaining screws. (bolts)
3) Remove headlamp unit to expose back of unit.
4) Disconnect wire connector from back of headlamp bulb.
5) Rotate retaining ring counterclockwise.
6) Remove retaining ring.
7) Pull headlamp bulb and remove from headlamp unit.
Installation
1) Install headlamp bulb to the headlamp unit.
2) Install headlamp bulb retaining ring.
3) Rotate retaining ring clockwise.
4) Connect wire connector to bulb.
5) Install headlamp unit.
6) Install headlamp retaining screws. (bolts)
7) Connect the battery negative cable.
More detailed info on how to get unit out.
Removal
1) Disconnect and isolate the battery negative cable.
2) Remove the two retaining screws.
3) Remove the upper fascia retainers by prying under the head of the fasteners with a flat bladed tool.
4) Remove headlamp unit from fender side first, then pull headlamp unit out.
5) Disconnect the wiring harness from the bulbs.
6) Remove the headlamp unit.
Installation
1) Connect wire harness to the bulbs.
2) Install headlamp unit.
3) Install the retaining screws.
4) Install upper fascia retainers.
5) Connect the battery negative cable.
I hope this will help you to get the light changed.
The hood latch is brock and I cant open the hood
if you can see your lock assembly through the grille, then you have a good chance og opening your hood, the lock assembly had a cable attached to it, i used a long handle screw driver and popped mine open, also did you try taking a pair of vise grips and locking them on the cable from the inside of the vehicle and pulling with a little force, that should open her right up. Good luck.
2006 sebring cut out at 2200
It could be the fuel filter, bad gas over a period of time, it could be a number of things. Try an additive called Seafoam, you can buy it at any auto parts store. Pour the whole bottle into your tank before you fill up and see if that helps. Maybe you have crude build up. It usually is from using cheap gas but I don't know a time frame of ownership of your car.
Not finding what you are looking for?