20 Most Recent 1994 Suzuki Sidekick Questions & Answers


Hi ,
Just download the manual from: http://auto.manualsonline.com/manuals/mfg/suzuki/1994.html

1994 Suzuki... | Answered on Jul 01, 2019


In the fuse box inside the car

1994 Suzuki... | Answered on Dec 20, 2017


Here's the link and I'm sure you will get the solution of your problem
SUZUKI SAMURAI SIDEKICK GEO TRACKER SERVICE REPAIR MANUAL 1986 1987 1988...

1994 Suzuki... | Answered on Oct 26, 2017


that book is super rare here.
its not on the car new, its dealer add on,
if you have this system just unplug it. (module)
it dont kill the engine in usa, (only the Europe ones do)
sidekick is 100% usa name Vitara else where, or GEO tracker here.

the dang thing only connects to door switches, good luck
using 23 year old orig. door switches, be bad bad idea
if hell bent on a alarm, use all new everything and it will work.
its not a security system only a super simple ALARM box.
the one with suzuki on it . label is a dealer added box.
we cant see yours, we be blind.
but most of these just unplug and all is good.

f0f52d9d-7a34-4a70-a37c-0415f3bae9fa.jpg

1994 Suzuki... | Answered on Mar 28, 2017


get front tries off crubs, or rocks or other things blocking them.
then turn key gently, (wiggle it)
and then turns steering (L/R wiggle it)
bam it unlocks, the operators guide covers this topic.

the lock is bad, needs wheel off.
ive done 2 this year,
the lock also has 2 anti tamper screws (clamp there) by LAW.
they must be removed with vise grip,et cetra.
then replaced with new 6mm bolts.

1: plastic shells off. (under neath shells)
2: see IGN switch, see it now> see how it surrounds the shafts>?
if you and seen that first, youd not be asking here, now.
ok>?
3: wheel off..
4: remove the 2 clamp bolts from switch assembly.
5: this lets column drop and free up switch assembly
6: now it can be removed

i had to.
The steering casing shaft at the floor firewall down low,, only loosen the 4 bolts 4-5 turns.(trick 1) there.
allows column to move more easy.

the FSM covers this, 96 car is nearly the same
and book is rare free, but is here.
turn to 3F4 page 7, and read,


http://www.acksfaq.com/2016bp.php?urlname=http://www.acksfaq.com/HTML/trackerfsm.htm

1994 Suzuki... | Answered on Mar 07, 2017


Check for proper amount of tranny fluid, If that is good then you have an issue needing an expert repair.

1994 Suzuki... | Answered on Aug 05, 2016


bell to engine, or bell to trans, some have side braces to trans.
3speed auto or 4 speed, ?
tough question, you lost ALL your bolts. (ouch) the are all metric.
the FSM nor the official Ecat, shows NO size.... (fact)
first off,.if not all lost then the other side there. are same size.
if the left is not missing , you have bolts to match to right.!
correct? take the left bolts to store and buy a match.
and the nuts. there.

there are 4 factors on these bolts. (suzuki still sells them)
1: diameter, most are 8 and 10 mm. measure the hole see that?
2: pitch, (iso spec sizes ) per above.
3: length (this too can be measured,)
4: grade. (id use grade 8.8) we dont have spec, so.... more is better.....
if not using OE parts.(suz)
you get to measure each hole first. (with a dial caliper)
measure inside diameter. or use 3 known bolts to find this out.
the MM diameter. 25.4 x inches = metric,

there are 2 big studs there too.
and finding that nut sizes is not hard. at all.
get diameter with caliper then buy the ISO pitch nut matching that.
there are fine and coarse ISO sizes. just looking answers that.
but if not, buy 2 nuts, that diameter in both fine and coarse.
bingo the nut is found.
as seen here
http://www.fixkick.com/tranny/slush/slide3L30/html/image_1.html


that same dial caliper tool (all shops have one..so.)
the rear measure depth. (basics)
the rear is insert in to a hole on trans to the block side and total depth is known (to rear edge of bell casing)
so buy mm length just less than that.
there is no easy way, only using a tool finds this out.
or use stick pushed in to hole an use thumb nail to mark stick
then measure that with any metric ruler. directly.

or just buy them. (they have no graphics for this level of detail back then so cant see them , must ask)
http://www.suzukicarparts.com/parts/1994/Suzuki/Sidekick/JLX/?siteid=214820&vehicleid=9153&searchText=

you will have to call them and tell them what's missing.
if you had listed all bolts missing i can give out real suz. part numbers. (i have a real hard copy parts list manual)


all this above is standard shop practices... how to measure bolts.

1994 Suzuki... | Answered on Aug 14, 2015


Any codes set? If not, check for spark at plugs. If none, could be coil/module, cam/crank sensor but last two usually set code. May be worth reading codes even if no check engine light on. Parts stores can often test modules for free.

1994 Suzuki... | Answered on Feb 10, 2015


It could be the fuel pump, could also be dirty injectors. You will have to hook up a fuel psi gauge at the schreater valve (looks like a tire valve) and check psi. 4 to 6 psi I think. If ok, then dirty throttle intake and injectors are a possibility. Let me know!

1994 Suzuki... | Answered on Feb 10, 2015


Here is the part number for Dorman which are available in the U.S. as Suzuki has left the country an OEM part could be tuff to find. Dorman Fuel Level Sending Unit Part Number: 31-05055062

1994 Suzuki... | Answered on Feb 04, 2015


belt fell off.

1994 Suzuki... | Answered on Jul 30, 2014


First off DO NOT START or DRIVE this vehicle until this leak is fixed. It is a fireball waiting to happen!


Replace your EGR valve. You might be able to save it by cleaning with carbuertor cleaner but likely not if it is leaking "from the diaphragm" already, but try the $5 can of cleaner first instead of the $100 part if I were you. 2nd leak reported from the exhaust manifold area is likely from the leaking EGR valve. Replace or fix the valve first, then let the existing gasoline pooled on top of your engine evaporate before starting the car. Just starting it could set off the flashpoint of the pooled gasoline from your igntion system spark. Once the fuel has evaportated and you have fixed or replaced your EGR valve, start it and run for several minutes. Use a mirror and flashlight to make sure you do not have another leak somewhere. Good luck and be careful!

1994 Suzuki... | Answered on Apr 22, 2014

Not finding what you are looking for?
1994 Suzuki Sidekick Logo

289 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Suzuki Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Sidekick Suzuki

  • Sidekick Suzuki

Most Popular Question

16 valve fuel injected 1994 new fuel

  • Cars & Trucks
Loading...