2001 Suzuki Esteem - Answered Questions & Fixed issues

Clutches inside transmission need to be replaced
I'm

The only difference is manual or automatic transmission

Any OBD2 codes?

I need a location of my oil dipstick on a 1999 Suzuki esteem

In fuel tank

Its normally on the side of the motor with the manifold.

the whole assembly or just the bulb.? post symptoms? i was in a crash. the lamp is just out, low beam is dead. like that.??? in Europe the lamps have auto aiming , one more little possible. this is covered ijn the operators guide, lost that, little gem? open glove box. extract the guide, read that, RTM or buy it for $4 bucks? https://suzukipitstopplus.com/Products/1026-2001-2002-esteem-owners-manual.aspx

if you turn the key off while there running of coarse there going to stop in different places have to tunr wipers off the they will go to home psition

follow this link click on torque tables and look up your vehicle http://www.speedwayautoparts.com/index35.htm

Clogged air filter.

2001 Esteem A/T tranny.? 4speed? (check fuses yet?) this transmission shifts via the TCM electronic brain. and will throw (store, or live) DTC errors. IN USA all these cars are OBD2 compliant and all scan tools work here, you plug it in , and drive and see if there are TRANNY DTC errors. all cars 1996 and newer, do that. (for sure Suz) these errors are covered in the FSM and tells you what tests to do , to isolate (and diagnose) what is wrong. in and out. what does that mean.? to a false neutral? or to 2nd? what? btw2, the TCM on this car also goes to limphome mode. when certain DTCs are set. and will skip gears at that moment. my suz,, both skip 2nd gear in limphome mode. The TCM needs good inputs or it can't work right. it has many inputs. shifter switch PRNDL. VSS1, VSS2 (veh,speed,sensors) TPS. (throttle angle.) ECT. (engine heat) btw3: this trans, 4speed, you can do the unplug test on it (FSM) and it works like a manual transmission, see the FSM for how to do that, this test proves the trans is ok, and the TCM is cause or its inputs are bad.

do you have coolant

in side the transmission, drop pan, bingo.

faulty relay is what i would be chasing

why not post the symptoms? no start, what? id bet 100% its not bad, what to find the truth, use a scan tool to see RPMs on OBD2 scan, shows 0 rpm crankiing and cranking for 5 seconds (release key,not off) see P0340 or P0355 or simular DTC? do you? bingo !! The ECU does tell you if the CKP is bad. sure does. if you look. saving big money if not.

Problem with 2001 Suzuki Esteem O2 sensor chevy ?????????????????????????????????????? is this an engine swap, chev to suz or suz to chev? and what is the quesiton, no actual question was posted, ????????

SOMETIMES THERE IS A SCREW THROUGH THE FACE OF THE ROTOR BETWEEN THE LUG STUDS. IF YOU CANT GET IT LOOSE IT IS OK TO DRILL IT OUT. IT IS ONLY THERE TO HOLD THE ROTOR ON DURRING PRODUCTION.

Doubtful it is badSeek a different shop & be there,so you can see the actual testingor forget itMost likely not even the problemYou can get one from a salvage yardor online & install yourselfDon't need a shop to remove 4 bolts

alldata.comits your friend, for all cars made.

you need and expert mechanic to look and access this damage.its non trivial.. and if not investigated proper can be very dangerous.if really curious of all the long steps to do this,alldata.com is your ticket.