20 Most Recent 2001 Lexus Gs 300 Questions & Answers

Your vehicle does not come equipped with an inertia fuel shut off switch. You will need to look elsewhere for this system failure. Possible causes could be: Anti theft (SRS) system, blow fuse, Relay, module, bad pump, wiring or connection or out of fuel. Please let me know if there is anything else I can help you with.

Something is being over looked. Diagnostics have to be performed to find out if this is related or a coincidence. I would first look, inspect and verify that the main accessory fuses are receiving 12 volts and are still properly grounded. What do you have for test equipment? Do you own a Power Probe, test light or multimeter? Please write back and let me know what tests you have run and what you have found so far. Most of these circuits are wired so they receive power when the key is in the ACC or RUN position and are activated from the Ground side.

Check this website you find there fuse box diagram and description for Lexus GS300 (2001 - 2002) Lexus GS300 2001 2002 fuse box diagram Auto Genius

On this website you find fuse box diagram and description for Lexus GS300 (2001 - 2002) Lexus GS300 2001 2002 fuse box diagram Auto Genius

you have 4 sensors. bank 1 sensor 1 - bank 1 sensor 2 - bank 2 sensor 1 - bank 2 sensor 2. it depends on which one is defective.

P0715 Input/Turbine Speed Sensor Circuit Malfunction U are going to have to pull the pan off the transmission and check/replace the input shaft turbine speed sensor.

Noise are very hard to diagnose if you are there, so over the key board it is darn near impossible. Please have a trained technician listen to this.

your blend door on your passenger side is most likely stuck in the cold position. Chances are you cable is broken. Good luck.

Disconnect battery cables. Hold ends together for 60-90 seconds. Turn key on RUN, just like you drive it. attach battery cables, start car. If that does not work, you will need a Lexus professional and a remote.

VSC is a system that helps prevent side skids and help stabilize the vehicle while turning on a curve. Is the Check Engine Light on also? (picture of an engine). If the check engine light is on then have someone fix that first because if there is a fault in the engine controls then your vehicle will turn off the VSC system automatically. If no Check Engine Light then either a re-calibration by a repair shop, a bad part in the VSC or the switch is turned off.

your car is starting to build up carbon in the intake and cannot keep the air flowing , when you have this kind on miles this is what starts to happen ,you ck eng light will come on with a po 401 shortly

Blocked Exhaust Converter ? Low Fuel Pressure ? Only testing will give you the answer