Top 20 1999 Acura Integra Questions & Answers

Apply power to the horn and see if it still works ... if yes check the wires to it especially the ground ... if all is good then check in the steering wheel.

you need to find the kill switch and remove the wires from the switch and attach them together if it is a 2 wire switch, lights dimming on break application is due to a short in the wires, common problem with integras 94-2001

possible sender unit on the gear box has oil in it or wiring is broken or fallen off

Just remove it. It shouldn't be too hard, take all the parts and harness out, reconnect any cut wires and wrap any exposed wires with electrical tape.

spark misfire. what are the fault codes

It's underneath the floor panel, under the carpet on the passenger side of the interior compartment. You'll have to pull back the carpet to see what I mean.

just did

do the FSM testson the fan. yet? its all there. The RAD fan on many cars. can be complex. but all fans turn on, parked and idling, and allowed to overheat. (no air across rad core makes that happen) the tricks are , some cars have 2 fans, or fan with complex logic rules. based on engine heat and A/C load. the fan trips can have Hysteresis (start temp ,different from drop out) so read the manual the FSM. or at alldata.com

under the power steering fluid cap open the operators guide turn to how to check fluid. see cap in the photo the pump is there or at a hose attached to said fluid tank. easy huh? $19 on fleabay http://www.ebay.com/itm/1999-Acura-Integra-Owners-Manual-User-Guide-Reference-Operator-Book-Fuses-OEM-/360469981980?pt=Motors_Manuals_Literature&hash=item53edaf6b1c&vxp=mtr

normally when an aftermarket stereo is installed the yellow wire is for constant power gets connected with the ignition power wire and what you said is what happens in result. get a multimeter, set it onto dc volts and put the black lead onto something metal and then id use the red lead to test wires for a constant 12volts when key is in the off position. Once a wire is found connect it to the yellow wire of the stereo

what is the "control canister system"? What is it suposed to control?

Possible loose battery cables or corroded battery terminals...

check for cracks in the rubber and if there is too much flex. They are generally rubber and you should be able to figure out is they need replacing. After 14 years (if not replaced) it is a safe bet the money to replace them will not be wasted.

Hi,The car doesn't have a remote release lever on the driver's side floor in front of the driver's seat- where the gas door lever might be too?Try pushing DOWN on the hatch while either turning the key or moving the lever. Look in the Owner's Manual (or download one online).TD

you need a noid light to verify the injector is getting a signal, if you can't get one, swap injector 3 with another see if the miss follows it, if it does, install a new injector. GL

If you see signs of a leak such as oil on the pavement or oil on the side of the engine you may need to replace the main seals. Also check your valve cover gaskets. If there is no leak check the oil for signs of water getting into your oil, such as droplets on the dipstick in witch case you may have a blown head gasket or a cracked block. That is the worst case scenario. check your tail pipe for blue smoke while the engine is running, If you see this, you may need to replace the piston rings.

shot the tranny need vw bug or viper

p1457 is defined as an evap system leak on the canister side of the system.p1457 is for the charcoal cannister. Check the lines to make sure there isn't a leak. Otherwise, replace the cannister. First check for the leak,if there is no leak then its canister problem causing this error. You need a special smoke machine to run smoke through the machine and pinpoint the leak.At local garages they have smoke machine and pressure tools to check the leak. Keep updated with more queries.Thanks.

This warning light goes on periodically to tell you to take your Acura for maintenance. This does not mean that your car actually needs maintenance, it just means that your car thinks it needs maintenance. There is a small button forward of the steering wheel down towards the floor. The button is recessed just forward of the plastic covering. Hold this button for 10-20 seconds just after starting the car. The light should go out, but be aware it may come back on again in the future.

you need to first retrieve radio serial number which requires its removal.once you have serial number acura can nuse it to request registered radioanti-theft code.then type in 5 digit code.to unlock radio