1999 Acura Integra - Answered Questions & Fixed issues
1999 acura integra horn
Apply power to the horn and see if it still works ... if yes check the wires to it especially the ground ... if all is good then check in the steering wheel.
10/22/2017 4:41:35 AM •
1999 Acura...
•
Answered
on Oct 22, 2017
•
142 views
Im always adding oil to my 1999 acura integra.
If you see signs of a leak such as oil on the pavement or oil on the side of the engine you may need to replace the main seals. Also check your valve cover gaskets. If there is no leak check the oil for signs of water getting into your oil, such as droplets on the dipstick in witch case you may have a blown head gasket or a cracked block. That is the worst case scenario. check your tail pipe for blue smoke while the engine is running, If you see this, you may need to replace the piston rings.
6/6/2016 1:16:15 AM •
1999 Acura...
•
Answered
on Jun 06, 2016
•
79 views
Need code for 1999 acura integra radio
Hi:
You have to go to your Integra dealer to get that, due to the fact it is an anti theft code. Of ten they also need the number off the top of the radio too.
This keeps thieves from selling stolen radios...
4/29/2015 4:25:39 PM •
1999 Acura...
•
Answered
on Apr 29, 2015
•
680 views
Head unit not getting the right constant power
normally when an aftermarket stereo is installed the yellow wire is for constant power gets connected with the ignition power wire and what you said is what happens in result. get a multimeter, set it onto dc volts and put the black lead onto something metal and then id use the red lead to test wires for a constant 12volts when key is in the off position. Once a wire is found connect it to the yellow wire of the stereo
6/4/2014 4:06:39 AM •
1999 Acura...
•
Answered
on Jun 04, 2014
•
114 views
Cooling fan
do the FSM testson the fan. yet?
its all there.
The RAD fan on many cars. can be complex.
but all fans turn on, parked and idling, and allowed to overheat.
(no air across rad core makes that happen)
the tricks are , some cars have 2 fans, or fan with complex logic rules.
based on engine heat and A/C load.
the fan trips can have Hysteresis (start temp ,different from drop out)
so read the manual the FSM.
or at alldata.com
2/13/2014 2:43:47 PM •
1999 Acura...
•
Answered
on Feb 13, 2014
•
44 views
Engine mounting.
check for cracks in the rubber and if there is too much flex. They are generally rubber and you should be able to figure out is they need replacing. After 14 years (if not replaced) it is a safe bet the money to replace them will not be wasted.
12/12/2013 12:20:30 AM •
1999 Acura...
•
Answered
on Dec 12, 2013
•
39 views
Where is poweri steering pump
under the power steering fluid cap
open the operators guide
turn to how to check fluid. see cap in the photo
the pump is there or at a hose attached to said fluid tank.
easy huh?
$19 on fleabay
http://www.ebay.com/itm/1999-Acura-Integra-Owners-Manual-User-Guide-Reference-Operator-Book-Fuses-OEM-/360469981980?pt=Motors_Manuals_Literature&hash=item53edaf6b1c&vxp=mtr
11/30/2013 5:00:07 PM •
1999 Acura...
•
Answered
on Nov 30, 2013
•
145 views
Hatch won't open
Hi,The car doesn't have a remote release lever on the driver's side floor in front of the driver's seat- where the gas door lever might be too?Try pushing DOWN on the hatch while either turning the key or moving the lever. Look in the Owner's Manual (or download one online).TD
10/6/2012 4:44:28 AM •
1999 Acura...
•
Answered
on Oct 06, 2012
•
366 views
Engine light flashing
you need a noid light to verify the injector is getting a signal, if you can't get one, swap injector 3 with another see if the miss follows it, if it does, install a new injector. GL
8/18/2012 7:04:26 PM •
1999 Acura...
•
Answered
on Aug 18, 2012
•
90 views
My yellow maintenance light is
This warning light goes on periodically to tell you to take your Acura for maintenance. This does not mean that your car actually needs maintenance, it just means that your car thinks it needs maintenance. There is a small button forward of the steering wheel down towards the floor. The button is recessed just forward of the plastic covering. Hold this button for 10-20 seconds just after starting the car. The light should go out, but be aware it may come back on again in the future.
1/6/2011 2:34:05 AM •
1999 Acura...
•
Answered
on Jan 06, 2011
•
223 views
I need the radio code
you need to first retrieve radio serial number which requires its removal.once you have serial number acura can nuse it to request registered radioanti-theft code.then type in 5 digit code.to unlock radio
10/30/2010 5:14:19 AM •
1999 Acura...
•
Answered
on Oct 30, 2010
•
426 views
Not finding what you are looking for?