20 Most Recent 2002 Honda Odyssey Questions & Answers

Your O2 sensor (or oxygen sensor) is located on your exhaust system. One placed before your coverter to measure the efficiency of the combustion in your engine by measuring the amount of oxygen left in the exhaust stream. The second O2 sensor is placed after the converter and its job is to measure the effiecency of the converter in filtering out harmful gases in the exhaust by compairing its reading to the sensor paced before the converter. If your O2 sensor has failed it will tell the car's computer that it is running too lean (more air than fuel) by default. Since the computer thinks the car is running lean, it now is adding more fuel to the mixture to try and compensate for the lean condition and will always have a check engine light on. If there is no check engine light on then it probably is not a faulty O2 sensor. Have a qualified technician run a fuel consumption test and go from there.

no magic wand to wave and bypass or hotwire vehicle and an 02 vin key is about $30 to $50 dollars re try to jump vehicle with different cables and or test cables if using the same ones sounds like cables arent good

Check the alignment of the pulleys.

check and test relays you really dont hear an immobilizer kicking out most likely a relay overheating --also scan vehicle for code[s]

There is a relay for every window check the relays

If it is on the rear of the engine in front of the converter you need the bank 1 sensor 1. Behind the converter is bank 1 sensor 2. The front exhaust manifold is bank 2 so sensor in front of the converter is bank 2 sensor 1 and behind is bank 2 sensor2.

Are you getting a check engine light? If so, the sensor is rarely the problem. You need to check that the timing chain didn't skip or stretch. If it did (which is a possibility with that Honda motor 2002-2006), it needs to be serviced before driving it. If the timing's off, you can bend the valves and it's over.

Accessing Your Honda Radio Code Online Visit https://radio-navicode.honda.com/. You will need your Vehicle Identification Number (VIN), phone number and zip code matching the information on file with Honda, and the device serial number. You can retrieve your code through the website Sunday-Friday 4:00AM - 9:00PM PST and from 4:00AM - 6:30PM on Saturdays To Access Your Honda Radio Code via Phone Call Honda America Client Services at 1-800-999-1009. You will be required to provided your VIN number, radio serial number, as well as proof of ownership. To Access Your Honda Radio Code from a Dealership Drive to your local Honda or Acura dealer and provide your radio serial number and proof of ownership. Your radio code will not change, so once you've retrieved it, write the code down for any future use. https://radio-navicode.honda.com/ IF YOU NEED RADIO CODE PLEASE READ THIS THREAD Honda Tech

Your missing it's electronically controlled by computers , the driver & passenger & sliding door control modules . Do yourself a favor an take it to a qualified repair shop that knows how it works .

Library in auto section

You need a clutch rebuild.

I had the same problem and it ended up being the sensor for the gas door. Another symptom in my case was the gas door not openning. The sensor doubles as a spring to pop the gas door open. I didn't want to mess up my storage compartment like danielbeaty, but it was harder. I took the kickplate off and the trim from around the rear panel, and a couple of screws, and was able to reach in and unplug the sensor. I'm in the process of posting the procedure in more detail.

Hi All safety devices fitted in the vehicle will have to be reset through diagnostic computer. Also if the fault is not fixed then the light will return immediatley thanks