20 Most Recent 2004 Honda CR-V Questions & Answers

ourhowse, you may know cars, but you DON'T know the CRV. Both the automatic and manual transmission have drain plugs basically like the oil pan. Look at several of the online videos.

The clue is both items do not work. Check the lighting fuse rail.

the solenoid is bad, seems the coil is shorted out or its connector rusty. causing it to short? or hit by roaD HAZARDS, TO THAT CABLE? live in the RUST belt? (salted roads) the service manual cover all steps to get there ,pan off etc. https://eautorepair.net/Marketing/Default.asp

It could be the pins in the ignition are damaged and need to be replaced. I had the same problem with my 2004 CRV. If you happen to have a skilled locksmith in your area, they can fix it for loads cheaper than an auto mechanic, who would likely want to replace the entire ignition, in which case you'd need new keys programmed and all this other stuff that is time consuming and therefore costly. Good luck.

check fuses

You say that the rear wheel is stiff? Check to see if something is jammed in the rotors or the wheel is not centered on the hub. Did something get bent when the rear was lifted to change the struts?

When you changed the sensor did you clear the codes if not go to auto zone and clear them see if that helps

Don't post your s/n & vin online!!

FREE and EASY methods to get your Honda radio UNLOCK CODE. (Dealerships usually charge)

Assuming you don't have the Anti-Theft Code and Serial Number that is found on the credit card sized Anti-Theft Radio Identification Card that comes with the vehicle at the time of purchase and is usually found in the glove compartment....

You have FREE options to retrieve that code by phone or on the internet BUT, the RADIO SERIAL NUMBER is REQUIRED (no matter what). (see bottom about removing ERROR E3)

***IF your Honda was made BEFORE 2001 the serial number MAY not be accessible without removing the radio from the vehicle.***

* TO GET THE SERIAL NUMBER (so that you can get the unlock code)

1. Get something to write with and on (you'll need it to write down the serial number)
2. Put the ingnition key in and turn it until your able to turn your radio on (accessories position).
3. Then turn your radio OFF by it's knob/button (but leave the ingition key in place).
4. Hold down the preset buttons 1 and 6 at the same time.
5. Turn the radio on while pressing down both the 1 and 6 buttons.(***IF your Honda doesn't have preset buttons on the radio then hold down the top part of the 'Seek/Skip' button AND the top part of the 'Change Disk' button instead.*** )
6. Write down the 4 numbers you see first and then 4 more that display. These eight numbers are the SERIAL NUMBER. This is NOT your CODE.
7. Make sure your VIN (Vehicle Identification Number) is handy to get the unlock code. (can be found on your insurance card, driver's side door jam, small plate on dashboard by registration and inspection stickers, etc)

* TO GET THE UNLOCK CODE (using the radio Serial Number and VIN)

---Internet option:

1. Go to https://radio-navicode.honda.com/ (YES, it's run BY HONDA and IT'S FREE)
2. Follow on screen instructions (Serial Number and VIN required)
3. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

-OR-

---Telephone option:

1. Call American Honda Customer Relations (800) 999-1009
2. When the automated message starts 'Press 3' for 'Radio and Navigation Codes'.
3. Tell the Customer Service Agent you need your radio code. (They will ask for your name, your radio's serial number, VIN, etc)
4. When they give you your radio unlock code--WRITE IT DOWN and KEEP IT SAFE!
5. Type in the 5 digit code into your radio. This will unlock the radio and return it to a functional state.

* REMOVING ERROR E3

****If you entered too many wrong codes and got an ERROR E3 message displaying you'll need to do an additional step for even the correct unlock code to work.****

Disconnect your negative battery terminal (or pull the radio fuse out if that's easier for you) for 30 seconds then reconnect it and then the radio will say "CODE" again and you can put in your correct unlock code.

-----------------------------------------------------------------------------------
So what happened to begin with?
See also: http://automobiles.honda.com/information/frequently-asked-questions.aspx?Question=2

If the power from your battery to the Honda radio is interrupted the Anti-Theft feature kicks in, the radio is rendered inoperable and the screen reads 'CODE'. You must enter in the Anti-Theft Radio Unlock Code (usually 5 digits) to make it operational again. You know that much by now.

Where the cables go from the door into the pillar in a rubber cover, it is very normal for them to break on older cars, a pain job but take the rubbers off and you ar likely to find damaged wires!!

Flat battery in the car ?

honda crv Try this manual link that will help you get solutions to all of your vehicle problems. It's 100% complete and will do all your mechanics' work

Visit the on-line store, known as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Honda

Most vehicles are vacuum actuated heat and A/C under dash and the blend door on your is staying closed and covering the heater core so no heat can enter. The blend door vacuum line is most likely crimped closed or disconnected. Look on top of the heater box for said actuator and the door hinge to check it. You may be able to see it even.